21
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Investigation of Position Sensing and Energy Harvesting of a Flexible Triboelectric Touch Pad

      Nanomaterials
      MDPI

      Read this article at

          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Triboelectric nanogenerator (TENG) is a promising technology because it can harvest energy from the environment to enable self-sustainable mobile and wearable electronic devices. In this work, we present a flexible touch pad capable of detecting the contact location of an object and generating substantial energy simultaneously based on the coupling of triboelectric effects and electrostatic induction. The touch pad consists of Polytetrafluoroethylene (PTFE) thin film, multiple Aluminum (Al) electrodes and Polyethylene terephthalate (PET) layers, which can be achieved through low cost, simplified and scalable fabrication process. Different from the conventional multi-pixel-based positioning sensor (i.e., large array of sensing elements and electrodes), the analogue method proposed here is used to implement the positioning function with only four electrodes. Position location can achieve a detecting resolution of as small as 1.3 mm (the size of locating layer is 7.5 cm × 7.5 cm). For the energy harvesting part, a multilayer structure is designed to provide higher current output. The open circuit voltage of the device is around 420 V and the short circuit current can reach up to 6.26 µA with current density of 0.25 µA/cm2. The maximum output power obtained is approximately 10 mW, which is 0.4 mW/cm2. The flexibility and significantly reduced number of electrodes enable the proposed touch pad to be readily integrated into portable electronic devices, such as intelligent robots, laptops, healthcare devices, and environmental surveys, etc.

          Related collections

          Most cited references48

          • Record: found
          • Abstract: found
          • Article: not found

          Progress in triboelectric nanogenerators as a new energy technology and self-powered sensors

          A review on the principles, novel applications and perspectives of triboelectric nanogenerators as power sources and as self-powered sensors.
            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Transparent triboelectric nanogenerators and self-powered pressure sensors based on micropatterned plastic films.

            Transparent, flexible and high efficient power sources are important components of organic electronic and optoelectronic devices. In this work, based on the principle of the previously demonstrated triboelectric generator, we demonstrate a new high-output, flexible and transparent nanogenerator by using transparent polymer materials. We have fabricated three types of regular and uniform polymer patterned arrays (line, cube, and pyramid) to improve the efficiency of the nanogenerator. The power generation of the pyramid-featured device far surpassed that exhibited by the unstructured films and gave an output voltage of up to 18 V at a current density of ∼0.13 μA/cm(2). Furthermore, the as-prepared nanogenerator can be applied as a self-powered pressure sensor for sensing a water droplet (8 mg, ∼3.6 Pa in contact pressure) and a falling feather (20 mg, ∼0.4 Pa in contact pressure) with a low-end detection limit of ∼13 mPa.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Triboelectric-generator-driven pulse electrodeposition for micropatterning.

              By converting ambient energy into electricity, energy harvesting is capable of at least offsetting, or even replacing, the reliance of small portable electronics on traditional power supplies, such as batteries. Here we demonstrate a novel and simple generator with extremely low cost for efficiently harvesting mechanical energy that is typically present in the form of vibrations and random displacements/deformation. Owing to the coupling of contact charging and electrostatic induction, electric generation was achieved with a cycled process of contact and separation between two polymer films. A detailed theory is developed for understanding the proposed mechanism. The instantaneous electric power density reached as high as 31.2 mW/cm(3) at a maximum open circuit voltage of 110 V. Furthermore, the generator was successfully used without electric storage as a direct power source for pulse electrodeposition (PED) of micro/nanocrystalline silver structure. The cathodic current efficiency reached up to 86.6%. Not only does this work present a new type of generator that is featured by simple fabrication, large electric output, excellent robustness, and extremely low cost, but also extends the application of energy-harvesting technology to the field of electrochemistry with further utilizations including, but not limited to, pollutant degradation, corrosion protection, and water splitting.
                Bookmark

                Author and article information

                Journal
                10.3390/nano8080613
                https://creativecommons.org/licenses/by/4.0/

                Comments

                Comment on this article