15
views
0
recommends
+1 Recommend
1 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      RESIDENTIAL DRAIN WATER HEAT RECOVERY SYSTEMS: MODELING, ANALYSIS, AND IMPLEMENTATION

      research-article

      Read this article at

      ScienceOpenPublisher
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          This paper describes the design and environmental improvements that can be achieved using drain water heat recovery systems (DWHR) to reduce the energy consumption associated with residential showering. DWHR systems transfer heat from hot drain water to the shower’s incoming cold water stream, thus reducing the demand on the hot water heater. There are various DWHR systems available that differ in heat exchanger type, cost, and performance. This article focuses on designing a flat plate and gravity fed heat exchangers for a range of residential showering conditions. This is useful since there currently is no peer-reviewed published data on the effectiveness of DWHR, nor is there published research considering the emissions reductions that can be achieved with realistic DWHR systems. The governing equations for heat exchangers are used to model empirical data and to derive implementation recommendations for DWHR design. The model is validated using a prototype flat plate heat exchanger and test stand under varying flow rates and temperatures. A Monte Carlo simulation of the results showed that DWHR could save an average $74 a year for homes with natural gas water heaters and $160 a year for homes with electric water heaters. This corresponds to 0.3 metric tons and 1.5 metric tons of CO 2 offset per home per year for natural gas and electric water heaters, respectively. The results are compiled and organized into a software program that allows consumers to input their household showering habits and location to get an estimate of their CO 2, energy, and cost savings to determine if they should install a DWHR system.

          Related collections

          Most cited references3

          • Record: found
          • Abstract: not found
          • Book: not found

          “PP-1A-30 Single Point C - Frame Press Specification Sheet.”

          (2024)
            Bookmark
            • Record: found
            • Abstract: not found
            • Article: not found

            “A theoretical approach to predict the performance of chevron type plate heat exchangers.”

              Bookmark
              • Record: found
              • Abstract: not found
              • Book: not found

              “PP-1A-30 Single Point C - Frame Press Specification Sheet.”

              (2024)
                Bookmark

                Author and article information

                Journal
                jgrb
                Journal of Green Building
                College Publishing
                1552-6100
                1943-4618
                1943-4618
                Summer 2010
                : 5
                : 3
                : 85-94
                Author notes

                1. Graduate Student in Mechanical Engineering, University of Michigan, smbart@ 123456umich.edu

                2. Development Engineer Tecat Engineering, Inc. Ann Arbor, MI, fiskryanj@ 123456gmail.com

                3. Graduate Student Mechanical Engineering, Oakland University, afunk11@ 123456gmail.com

                4. Project Engineer, Bolton Conductive Systems, Walled Lake, MI, jhair921@ 123456gmail.com

                5. Associate Professor and Chair of Graduate Education, Mechanical Engineering, University of Michigan, skerlos@ 123456umich.edu

                Article
                jgb.5.3.85
                10.3992/jgb.5.3.85
                180d57cc-1f27-480c-812a-d5367a2f9e64
                ©2010 by College Publishing. All rights reserved.
                History
                Page count
                Pages: 12
                Categories
                RESEARCH ARTICLES

                Urban design & Planning,Civil engineering,Environmental management, Policy & Planning,Architecture,Environmental engineering

                Comments

                Comment on this article