Flow-induced voltage generation in non-ionic liquids over monolayer graphene

The recent discovery of graphene has sparked significant interest, which has so far been focused on the peculiar electronic structure of this material, in which charge carriers mimic massless relativistic particle. However, the structure of graphene - a single layer of carbon atoms densely packed in a honeycomb crystal lattice - is also puzzling. On the one hand, graphene appears to be a strictly two-dimensional (2D) material and exhibits such a high crystal quality that electrons can travel submicron distances without scattering. On the other hand, perfect 2D crystals cannot exist in the free state, according to both theory and experiment. This is often reconciled by the fact that all graphene structures studied so far were an integral part of larger 3D structures, either supported by a bulk substrate or embedded in a 3D matrix. Here we report individual graphene sheets freely suspended on a microfabricated scaffold in vacuum or air. These membranes are only one atom thick and still display a long-range crystalline order. However, our studies by transmission electron microscopy (TEM) have revealed that suspended graphene sheets are not perfectly flat but exhibit intrinsic microscopic roughening such that the surface normal varies by several degrees and out-of-plane deformations reach 1 nm. The atomically-thin single-crystal membranes offer an ample scope for fundamental research and new technologies whereas the observed corrugations in the third dimension may shed light on subtle reasons behind the stability of 2D crystals.

We have developed a nanowire nanogenerator that is driven by an ultrasonic wave to produce continuous direct-current output. The nanogenerator was fabricated with vertically aligned zinc oxide nanowire arrays that were placed beneath a zigzag metal electrode with a small gap. The wave drives the electrode up and down to bend and/or vibrate the nanowires. A piezoelectric-semiconducting coupling process converts mechanical energy into electricity. The zigzag electrode acts as an array of parallel integrated metal tips that simultaneously and continuously create, collect, and output electricity from all of the nanowires. The approach presents an adaptable, mobile, and cost-effective technology for harvesting energy from the environment, and it offers a potential solution for powering nanodevices and nanosystems.

Results of room temperature Raman scattering studies of ultrathin graphitic films supported on Si (111)/SiO2 substrates are reported. The results are significantly different from those known for graphite. Spectra were collected using 514 nm radiation on films containing from n=1 to 20 graphene layers, as determined by atomic force microscopy. Both the 1st and 2nd order Raman spectra show unique signatures of the number of layers in the film. The nGL film analog of the Raman G-band in graphite exhibits a Lorentzian lineshape whose center frequency shifts linearly relative to graphite as ~1/n (for n=1 G-band frequency ~1588 cm-1). Three weak bands, identified with disorder-induced 1st order scattering, are observed at ~ 1350, 1450 and 1500 cm-1. The 1500 cm-1 band is weak but relatively sharp and exhibits an interesting n-dependence. In general, the intensity of these D-bands decreases dramatically with increasing n. Three 2nd order bands are also observed (~2450, ~2700 and 3248 cm-1). They are analogs to those observed in graphite. However, the ~2700 cm-1 band exhibits an interesting and dramatic change of shape with n. Interestingly, for n<5 this 2nd order band is more intense than the G-band.