8
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Effects of Graphene Nanoplatelet Size and Surface Area on the AC Electrical Conductivity and Dielectric Constant of Epoxy Nanocomposites

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Epoxy nanocomposites reinforced with various grades of multilayer graphene nanoplatelets (GNPs) are manufactured and tested. The effects of size, surface area, and concentration of GNP, as well as alternating current (AC) frequency on the electrical and dielectric properties of epoxy nanocomposites are experimentally investigated. GNPs with larger size and surface area are always beneficial to increase the electrical conductivity of the composites. However, their effects on the dielectric constant are highly dependent on GNP concentration and AC frequency. At lower GNP concentration, the dielectric constant increases proportionally with the increase in GNP size, while decreasing as the AC frequency increases. At higher GNP concentration in epoxy, the dielectric constant first increases with the increase of the GNP size, but decreases thereafter. This trend is also observed for varying the processed GNP surface area on the dielectric constant. Moreover, the variations of the electrical conductivity and dielectric constant with the GNP concentration and AC frequency are then correlated with the measured interfiller spacing and GNP diameter.

          Related collections

          Most cited references65

          • Record: found
          • Abstract: not found
          • Article: not found

          Carbon nanotube–polymer composites: Chemistry, processing, mechanical and electrical properties

            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Highly aligned graphene/polymer nanocomposites with excellent dielectric properties for high-performance electromagnetic interference shielding.

            Nanocomposites that contain reinforcements with preferred orientation have attracted significant attention because of their promising applications in a wide range of multifunctional fields. Many efforts have recently been focused on developing facile methods for preparing aligned graphene sheets in solvents and polymers because of their fascinating properties including liquid crystallinity and highly anisotropic characteristics. Self-aligned in situ reduced graphene oxide (rGO)/polymer nanocomposites are prepared using an all aqueous casting method. A remarkably low percolation threshold of 0.12 vol% is achieved in the rGO/epoxy system owing to the uniformly dispersed, monolayer graphene sheets with extremely high aspect ratios (>30000). The self-alignment into a layered structure at above a critical filler content induces a unique anisotropy in electrical and mechanical properties due to the preferential formation of conductive and reinforcing networks along the alignment direction. Accompanied by the anisotropic electrical conductivities are exceptionally high dielectric constants of over 14000 with 3 wt% of rGO at 1 kHz due to the charge accumulation at the highly-aligned conductive filler/insulating polymer interface according to the Maxwell-Wagner-Sillars polarization principle. The highly dielectric rGO/epoxy nanocomposites with the engineered structure and properties present high performance electromagnetic interference shielding with a remarkable shilding efficiency of 38 dB.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Lightweight, Superelastic, and Mechanically Flexible Graphene/Polyimide Nanocomposite Foam for Strain Sensor Application.

              The creation of superelastic, flexible three-dimensional (3D) graphene-based architectures is still a great challenge due to structure collapse or significant plastic deformation. Herein, we report a facile approach of transforming the mechanically fragile reduced graphene oxide (rGO) aerogel into superflexible 3D architectures by introducing water-soluble polyimide (PI). The rGO/PI nanocomposites are fabricated using strategies of freeze casting and thermal annealing. The resulting monoliths exhibit low density, excellent flexibility, superelasticity with high recovery rate, and extraordinary reversible compressibility. The synergistic effect between rGO and PI endows the elastomer with desirable electrical conductivity, remarkable compression sensitivity, and excellent durable stability. The rGO/PI nanocomposites show potential applications in multifunctional strain sensors under the deformations of compression, bending, stretching, and torsion.
                Bookmark

                Author and article information

                Journal
                Polymers (Basel)
                Polymers (Basel)
                polymers
                Polymers
                MDPI
                2073-4360
                27 April 2018
                May 2018
                : 10
                : 5
                : 477
                Affiliations
                [1 ]Sir Lawrence Wackett Aerospace Research Centre, School of Engineering, RMIT University, GPO Box 2476, Melbourne, VIC 3001, Australia; anil.ravindran@ 123456rmit.edu.au
                [2 ]School of Engineering, RMIT University, Bundoora, VIC 3083, Australia; shu.huang@ 123456rmit.edu.au (S.H.); s3415279@ 123456student.rmit.edu.au (Y.W.); s3494699@ 123456student.rmit.edu.au (Z.Z.)
                Author notes
                Author information
                https://orcid.org/0000-0002-1879-1950
                https://orcid.org/0000-0001-7696-5448
                Article
                polymers-10-00477
                10.3390/polym10050477
                6415418
                0b5958d6-f7b8-4d89-badb-2064a240f98b
                © 2018 by the authors.

                Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license ( http://creativecommons.org/licenses/by/4.0/).

                History
                : 03 April 2018
                : 25 April 2018
                Categories
                Article

                graphene platelet,epoxy nanocomposites,electrical conductivity,dielectric constant

                Comments

                Comment on this article