13
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: not found

      2D coherent charge transport in highly ordered conducting polymers doped by solid state diffusion.

      Read this article at

      ScienceOpenPublisherPubMed
      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Doping is one of the most important methods to control charge carrier concentration in semiconductors. Ideally, the introduction of dopants should not perturb the ordered microstructure of the semiconducting host. In some systems, such as modulation-doped inorganic semiconductors or molecular charge transfer crystals, this can be achieved by spatially separating the dopants from the charge transport pathways. However, in conducting polymers, dopants tend to be randomly distributed within the conjugated polymer, and as a result the transport properties are strongly affected by the resulting structural and electronic disorder. Here, we show that in the highly ordered lamellar microstructure of a regioregular thiophene-based conjugated polymer, a small-molecule p-type dopant can be incorporated by solid state diffusion into the layers of solubilizing side chains without disrupting the conjugated layers. In contrast to more disordered systems, this allows us to observe coherent, free-electron-like charge transport properties, including a nearly ideal Hall effect in a wide temperature range, a positive magnetoconductance due to weak localization and the Pauli paramagnetic spin susceptibility.

          Related collections

          Author and article information

          Journal
          Nat Mater
          Nature materials
          Springer Nature
          1476-1122
          1476-1122
          Aug 2016
          : 15
          : 8
          Affiliations
          [1 ] Cavendish Laboratory, University of Cambridge, J. J. Thomson Avenue, Cambridge CB3 0HE, UK.
          [2 ] Department of Advanced Materials Science, Graduate School of Frontier Sciences, The University of Tokyo, 5-1-5 Kashiwanoha, Kashiwa 277-8561, Chiba, Japan.
          [3 ] JST, PRESTO, 4-1-8 Honcho, Kawaguchi, Saitama 332-0012, Japan.
          [4 ] Adolphe Merkle Institute, University of Fribourg, Chemin des Verdiers 4, CH-1700 Fribourg, Switzerland.
          [5 ] Department of Chemistry and Centre for Plastic Electronics, Imperial College, London SW7 2AZ, UK.
          [6 ] Division of Materials Science, University of Tsukuba, Tsukuba, Ibaraki 305-8573, Japan.
          [7 ] Tsukuba Research Center for Interdisciplinary Materials Science (TIMS), University of Tsukuba, Tsukuba, Ibaraki 305-8571, Japan.
          [8 ] Department of Applied Physics, Nagoya University, Chikusa, Nagoya 464-8603, Japan.
          Article
          nmat4634
          10.1038/nmat4634
          27159015
          12a33cc9-2b47-483d-8dc2-f6448883e433
          History

          Comments

          Comment on this article