An optomechanical heat engine with feedback-controlled in-loop light

There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

Abstract

The dissipative properties of an optical cavity can be effectively controlled by placing it in a feedback loop where the light at the cavity output is detected and the corresponding signal is used to modulate the amplitude of a laser field which drives the cavity itself. Here we show that this effect can be exploited to improve the performance of an optomechanical heat engine which makes use of polariton excitations as working fluid. In particular we demonstrate that, by employing a positive feedback close to the instability threshold, it is possible to operate this engine also under parameters regimes which are not usable without feedback, and which may significantly ease the practical implementation of this device.

Related collections

Most cited references 5

Record: found
Abstract: found
Article: not found

Circuit cavity electromechanics in the strong-coupling regime.

J. Teufel, Dale Li, M. Allman … (2011)

Demonstrating and exploiting the quantum nature of macroscopic mechanical objects would help us to investigate directly the limitations of quantum-based measurements and quantum information protocols, as well as to test long-standing questions about macroscopic quantum coherence. Central to this effort is the necessity of long-lived mechanical states. Previous efforts have witnessed quantum behaviour, but for a low-quality-factor mechanical system. The field of cavity optomechanics and electromechanics, in which a high-quality-factor mechanical oscillator is parametrically coupled to an electromagnetic cavity resonance, provides a practical architecture for cooling, manipulation and detection of motion at the quantum level. One requirement is strong coupling, in which the interaction between the two systems is faster than the dissipation of energy from either system. Here, by incorporating a free-standing, flexible aluminium membrane into a lumped-element superconducting resonant cavity, we have increased the single-photon coupling strength between these two systems by more than two orders of magnitude, compared to previously obtained coupling strengths. A parametric drive tone at the difference frequency between the mechanical oscillator and the cavity resonance dramatically increases the overall coupling strength, allowing us to completely enter the quantum-enabled, strong-coupling regime. This is evidenced by a maximum normal-mode splitting of nearly six bare cavity linewidths. Spectroscopic measurements of these 'dressed states' are in excellent quantitative agreement with recent theoretical predictions. The basic circuit architecture presented here provides a feasible path to ground-state cooling and subsequent coherent control and measurement of long-lived quantum states of mechanical motion.

0 comments Cited 167 times – based on 0 reviews      Review now

Bookmark

Record: found
Abstract: found
Article: found

Is Open Access

Probing deformed commutators with macroscopic harmonic oscillators

Mateusz Bawaj, Ciro Biancofiore, Michele Bonaldi … (2015)

A minimal observable length is a common feature of theories that aim to merge quantum physics and gravity. Quantum mechanically, this concept is associated with a nonzero minimal uncertainty in position measurements, which is encoded in deformed commutation relations. In spite of increasing theoretical interest, the subject suffers from the complete lack of dedicated experiments and bounds to the deformation parameters have just been extrapolated from indirect measurements. As recently proposed, low-energy mechanical oscillators could allow to reveal the effect of a modified commutator. Here we analyze the free evolution of high-quality factor micro- and nano-oscillators, spanning a wide range of masses around the Planck mass m P (≈22 μg). The direct check against a model of deformed dynamics substantially lowers the previous limits on the parameters quantifying the commutator deformation.