The sensitivity of the acoustic waveguide sensor to mass deposition in the presence of liquid was optimized as a function of the over-layer thickness. The waveguide geometry consisted of a 0.2-2.2-microm poly(methyl)methacrylate (PMMA) over-layer deposited on the surface of a shear acoustic wave device and supported a Love wave. The response of each polymer-coated waveguide was initially assessed by monitoring the frequency and insertion loss of the device in the presence of air. Sensitivity to viscous and mass loading was studied by recording the amplitude and phase of the wave during the application of water and of a supported lipid bilayer, respectively, on the device surface. Supported bilayers are a versatile system for mass calibration in the presence of liquid because they can be formed spontaneously on a hydrophilic surface, resulting in a layer of reproducible mass density. Results clearly showed that the response of both amplitude and phase depends on the over-layer thickness and increases with the thickness of the polymer layer. Phase was generally found to be more sensitive than amplitude to both viscous water and mass loading. The maximum sensitivity to vesicles deposition was measured at 250 cm2 g(-1) and was detected when 1.3 microm of PMMA was used as a waveguide layer. Results showed that the sensitivity of the acoustic wave sensor can be improved by simply increasing the thickness of the PMMA and that supported phospholipid layers can form an ideal system for both mass calibration and interfacial modification.