14
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Citric Acid Enhanced Copper Removal by a Novel Multi-amines Decorated Resin

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Cu removal by a novel multi-amines decorated resin (PAMD) from wastewater in the absence or presence of citric acid (CA) was examined. Adsorption capacity of Cu onto PAMD markedly increased by 186% to 5.07 mmol/g in the presence of CA, up to 7 times of that onto four commercial resins under the same conditions. Preloaded and kinetic studies demonstrated adsorption of [Cu-CA] complex instead of CA site-bridging and variations of adsorbate species were qualitatively illustrated. The interaction configuration was further studied with ESI-MS, FTIR, XPS and XANES characterizations. The large enhancement of Cu adsorption in Cu-CA bi-solutes systems was attributed to mechanism change from single-site to dual-sites interaction in which cationic or neutral Cu species (Cu 2+ and CuHL 0) coordinated with neutral amine sites and anionic complex species (CuL and Cu 2L 2 2−) directly interacted with protonated amine sites via electrostatic attraction, and the ratio of the two interactions was approximately 0.5 for the equimolar bi-solutes system. Moreover, commonly coexisting ions in wastewaters had no obvious effect on the superior performance of PAMD. Also, Cu and CA could be recovered completely with HCl. Therefore, PAMD has a great potential to efficiently remove heavy metal ions from wastewaters in the presence of organic acids.

          Related collections

          Most cited references30

          • Record: found
          • Abstract: found
          • Article: not found

          Kinetic models of sorption: a theoretical analysis.

          The kinetics of sorption from a solution onto an adsorbent has been explored theoretically. The general analytical solution was obtained for two cases. It has been shown that at high initial concentration of solute (sorbate) the general equation converts to a pseudo-first-order model and at lower initial concentration of solute it converts to a pseudo-second-order model. In other words, the sorption process obeys pseudo-first-order kinetics at high initial concentration of solute, while it obeys pseudo-second-order kinetics model at lower initial concentration of solute. The theoretical results (derived equations) show that the observed rate constants of pseudo-first-order and pseudo-second-order models are combinations of adsorption and desorption rate constants and also initial concentration of solute. The obtained theoretical equations are used to correlate experimental data for sorption kinetics of some solutes on various sorbents. The predictions of the theory are in excellent agreement with the experimental data.
            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Interactions between alginate and chitosan biopolymers characterized using FTIR and XPS.

            This study investigates alginate-chitosan polyelectrolyte complexes (PECs) in the form of a film, a precipitate, as well as a layer-by-layer (LbL) assembly. The focus of this study is to fully characterize, using the complementary techniques of Fourier transform infrared (FTIR) spectroscopy and X-ray photoelectron spectroscopy (XPS) in combination with solution stability evaluation, the interactions between alginate and chitosan in the PECs. In the FTIR spectra, no significant change in the band position of the two carbonyl vibrations from alginate occurs upon interaction with different ionic species. However, protonation of the carboxylate group causes a new band to appear at 1710 cm(-1), as anticipated. Partial protonation of the amine group of chitosan causes the appearance of one new band ( approximately 1530 cm(-1)) due to one of the -NH3+ vibrational modes (the other mode overlaps the amide I band). Importantly, the position of the two main bands in the spectral region of interest in partly protonated chitosan films is not dependent on the extent of protonation. XPS N 1s narrow scans can, however, be used to assess the degree of amine protonation. In our alginate-chitosan film, precipitate, and LbL assembly, the bands observed in the FTIR correspond to the species -COO- and -NH3+, but their position is not different from each of the single components. Thus, the conclusion of the study is that FTIR cannot be used directly to identify the presence of PECs. However, in combination with XPS (survey and narrow N 1s scans) and solution stability evaluation, a more complete description of the structure can be obtained. This conclusion challenges the assignment of FTIR spectra in the literature.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Enhanced adsorptive removal of methyl orange and methylene blue from aqueous solution by alkali-activated multiwalled carbon nanotubes.

              An alkali-acitvated method was explored to synthesize activated carbon nanotubes (CNTs-A) with a high specific surface area (SSA), and a large number of mesopores. The resulting CNTs-A were used as an adsorbent material for removal of anionic and cationic dyes in aqueous solutions. Experimental results indicated that CNTs-A have excellent adsorption capacity for methyl orange (149 mg/g) and methylene blue (399 mg/g). Alkali-activation treatment of CNTs increased the SSA and pore volume (PV), and introduced oxygen-containing functional groups on the surface of CNTs-A, which would be beneficial to improving the adsorption affinity of CNTs-A for removal of dyes. Kinetic regression results shown that the adsorption kinetic was more accurately represented by a pseudo second-order model. The overall adsorption process was jointly controlled by external mass transfer and intra-particle diffusion, and intra-particle diffusion played a dominant role. Freundlich isotherm model showed a better fit with adsorption data than Langmuir isotherm model. Adsorption interactions of dyes onto CNTs-A from aqueous solutions were investigated using Fourier transform infrared (FT-IR) spectroscopy, scanning electron microscopy (SEM), X-ray diffraction (XRD), and Brunauer-Emmett-Teller (BET) method. The remarkable adsorption capacity of dye onto CNTs-A can be attributed to the multiple adsorption interaction mechanisms (hydrogen bonding, π-π electron-donor-acceptor interactions, electrostatic interactions, mesopore filling) on the CNTs-A. Results of this work are of great significance for environmental applications of activated CNTs as a promising adsorbent nanomaterial for organic pollutants from aqueous solutions.
                Bookmark

                Author and article information

                Journal
                Sci Rep
                Sci Rep
                Scientific Reports
                Nature Publishing Group
                2045-2322
                12 May 2015
                2015
                : 5
                : 9944
                Affiliations
                [1 ]State Key Laboratory of Pollution Control and Resource Reuse, School of the Environment, Nanjing University , Nanjing 210023, P. R. China
                [2 ]State Key Laboratory of Environmental Chemistry and Ecotoxicology, Research Center for Eco-Environmental Sciences, Chinese Academy of Sciences , Beijing 100085, China
                [3 ]Beijing Synchrotron Radiation Laboratory, Institute of High Energy Physics, Chinese Academy of Sciences , Beijing 100049, China
                [4 ]Stockbridge School of Agriculture, University of Massachusetts , Amherst, Massachusetts 01003, United States
                Author notes
                Article
                srep09944
                10.1038/srep09944
                4649996
                25962970
                2c612850-f4ca-4988-bc98-ef3b8a6a6dae
                Copyright © 2015, Macmillan Publishers Limited

                This work is licensed under a Creative Commons Attribution 4.0 International License. The images or other third party material in this article are included in the article’s Creative Commons license, unless indicated otherwise in the credit line; if the material is not included under the Creative Commons license, users will need to obtain permission from the license holder to reproduce the material. To view a copy of this license, visit http://creativecommons.org/licenses/by/4.0/

                History
                : 06 January 2015
                : 10 March 2015
                Categories
                Article

                Uncategorized
                Uncategorized

                Comments

                Comment on this article