Direct metal fabrication of titanium implants with tailored materials and mechanical properties using electron beam melting technology

There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

Abstract

Related collections

Most cited references 19

Record: found
Abstract: not found
Article: not found

Tailoring materials with prescribed elastic properties

Ole Sigmund (1995)

0 comments Cited 75 times – based on 0 reviews      Review now

Bookmark

Record: found
Abstract: found
Article: not found

Implant fixation by bone ingrowth.

C Sprey, P Griss, Russell A. Wilke … (1999)

The term osseointegration referred originally to an intimate contact of bone tissue with the surface of a titanium implant; the term bone ingrowth refers to bone formation within an irregular (beads, wire mesh, casting voids, cut grooves) surface of an implant. The section dealing with the historical background describes the development of macroporous, microporous, and textured surfaces with an emphasis on the evolution of porous and textured metal surfaces. The principal requirements for osseointegration and bone ingrowth are systematically reviewed as follows: i) the physiology of osseointegration and bone ingrowth, including biomaterial biocompatibility with respect to cellular and matrix response at the interface; ii) the implant surface geometry characteristics; iii) implant micromotion and fixation modes; and iv) the implant-bone interface distances. Based on current methods of bone ingrowth assessment, this article comparatively reviews and discusses the results of experimental studies with the objective of determining local and systemic factors that enhance bone ingrowth fixation.