28
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Improved PEDOT:PSS/c-Si hybrid solar cell using inverted structure and effective passivation

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          The PEDOT:PSS is often used as the window layer in the normal structured PEDOT:PSS/c-Si hybrid solar cell (HSC), leading to significantly reduced response, especially in red and near-infrared region. By depositing the PEDOT:PSS on the rear side of the c-Si wafer, we developed an inverted structured HSC with much higher solar cell response in the red and near-infrared spectrum. Passivating the other side with hydrogenated amorphous silicon (a-Si:H) before electrode deposition, the minority carrier lifetime has been significantly increased and the power conversion efficiency (PCE) of the inverted HSC is improved to as high as 16.1% with an open-circuit voltage (V oc) of 634 mV, fill factor (FF) of 70.5%, and short-circuit current density (J sc) of 36.2 mA cm −2, an improvement of 33% over the control device. The improvements are ascribed to inverted configuration and a-Si:H passivation, which can increase photon carrier generation and reduce carrier recombination, respectively. Both of them will benefit the photovoltaic performance and should be considered as effective design strategies to improve the performance of organic/c-Si HSCs.

          Related collections

          Most cited references11

          • Record: found
          • Abstract: found
          • Article: not found

          Solution-processed metallic conducting polymer films as transparent electrode of optoelectronic devices.

          The conductivity of PEDOT:PSS films was significantly enhanced from 0.3 S cm(-1) to 3065 S cm(-1) through a treatment with dilute sulfuric acids. PEDOT:PSS films with a sheet resistance of 39 Ω sq(-1) and transparency of around 80% at 550 nm are obtained. These PEDOT:PSS films with conductivity and transparency comparable to ITO can replace ITO as the transparent electrode of optoelectronic devices. Copyright © 2012 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.
            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Hybrid silicon nanocone-polymer solar cells.

            Recently, hybrid Si/organic solar cells have been studied for low-cost Si photovoltaic devices because the Schottky junction between the Si and organic material can be formed by solution processes at a low temperature. In this study, we demonstrate a hybrid solar cell composed of Si nanocones and conductive polymer. The optimal nanocone structure with an aspect ratio (height/diameter of a nanocone) less than two allowed for conformal polymer surface coverage via spin-coating while also providing both excellent antireflection and light trapping properties. The uniform heterojunction over the nanocones with enhanced light absorption resulted in a power conversion efficiency above 11%. Based on our simulation study, the optimal nanocone structures for a 10 μm thick Si solar cell can achieve a short-circuit current density, up to 39.1 mA/cm(2), which is very close to the theoretical limit. With very thin material and inexpensive processing, hybrid Si nanocone/polymer solar cells are promising as an economically viable alternative energy solution.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Role of majority and minority carrier barriers silicon/organic hybrid heterojunction solar cells.

              A hybrid approach to solar cells is demonstrated in which a silicon p-n junction, used in conventional silicon-based photovoltaics, is replaced by a room-temperature fabricated silicon/organic heterojunction. The unique advantage of silicon/organic heterojunction is that it exploits the cost advantage of organic semiconductors and the performance advantages of silicon to enable potentially low-cost, efficient solar cells.
                Bookmark

                Author and article information

                Journal
                Sci Rep
                Sci Rep
                Scientific Reports
                Nature Publishing Group
                2045-2322
                11 October 2016
                2016
                : 6
                : 35091
                Affiliations
                [1 ]Key Laboratory of Applied Surface and Colloid Chemistry, National Ministry of Education; Shaanxi Engineering Lab for Advanced Energy Technology; School of Materials Science & Engineering, Shaanxi Normal University , Xi’an, 710119, P. R. China
                [2 ]Department of Physics and Electronic Engineering, Yuncheng University, Yuncheng University , Yuncheng, 044000, P. R. China
                [3 ]Dalian Institute of Chemical Physics, Dalian National Laboratory for Clean Energy, Chinese Academy of Sciences , Dalian, 116023, P. R. China
                Author notes
                Article
                srep35091
                10.1038/srep35091
                5057131
                27725714
                6bcc1f6d-adb7-4aba-8d49-8c30c8dddf20
                Copyright © 2016, The Author(s)

                This work is licensed under a Creative Commons Attribution 4.0 International License. The images or other third party material in this article are included in the article’s Creative Commons license, unless indicated otherwise in the credit line; if the material is not included under the Creative Commons license, users will need to obtain permission from the license holder to reproduce the material. To view a copy of this license, visit http://creativecommons.org/licenses/by/4.0/

                History
                : 01 August 2016
                : 23 September 2016
                Categories
                Article

                Uncategorized
                Uncategorized

                Comments

                Comment on this article