7
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      A Facile Strategy to Enhance the Dielectric and Mechanical Properties of MWCNTs/PVDF Composites with the Aid of MMA-co-GMA Copolymer

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          A facile strategy is adopted to prepare carboxylic functionalized multiwalled carbon nanotube (c-MWCNT) modified high dielectric constant (high- k) poly(vinylidene fluoride) (PVDF) composites with the aid of methyl methacrylate-co-glycidyl methacrylate copolymer (MG). The MG is miscible with PVDF and the epoxy groups of the copolymer can react with the carboxylic groups of c-MWCNT, which induce the uniform dispersion of c-MWCNT and a form insulator layer on the surface of c-MWCNT. The c-MWCNTs/MG/PVDF composites with 8 vol % c-MWCNT present excellent dielectric properties with high dielectric constant (~448) and low dielectric loss (~2.36) at the frequency of 1 KHz, the dielectric loss is much lower than the c-MWCNT/PVDF composites without MG. The obvious improvement in dielectric properties ascribes to the existence of MG, which impede the direct contact of c-MWCNTs and PVDF and avoid the formation of conductive network. Therefore, we propose a practical and simple strategy for preparing composites with excellent dielectric properties, which are promising for applications in electronics devices.

          Related collections

          Most cited references41

          • Record: found
          • Abstract: found
          • Article: not found

          Ferroelectric polymers.

          A Lovinger (1983)
          Piezoelectricity and pyroelectricity, traditionally encountered in certain single crystals and ceramics, have now also been documented in a number of polymers. Recently, one such polymer-poly(vinylidene fluoride)-and some of its copolymers have been shown to be ferroelectric as well. The extraordinary molecular and supermolecular structural requirements for ferroelectric behavior in polymers are discussed in detail, with particular emphasis on poly(vinylidene fluoride). Piezoelectric, pyroelectric, and ferroelectric properties are also briefly reviewed, as are some promising applications of such polymers.
            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Giant electrostriction and relaxor ferroelectric behavior in electron-irradiated poly(vinylidene fluoride-trifluoroethylene) copolymer

            An exceptionally high electrostrictive response ( approximately 4 percent) was observed in electron-irradiated poly(vinylidene fluoride-trifluoroethylene) [P(VDF-TrFE)] copolymer. The material exhibits typical relaxor ferroelectric behavior, suggesting that the electron irradiation breaks up the coherent polarization domain (all-trans chains) in normal ferroelectric P(VDF-TrFE) copolymer into nanopolar regions (nanometer-size, all-trans chains interrupted by trans and gauche bonds) that transform the material into a relaxor ferroelectric. The expanding and contracting of these polar regions under external fields, coupled with a large difference in the lattice strain between the polar and nonpolar phases, generate an ultrahigh strain response.
              Bookmark
              • Record: found
              • Abstract: not found
              • Article: not found

              Physical Properties of Composites Near Percolation

                Bookmark

                Author and article information

                Journal
                Materials (Basel)
                Materials (Basel)
                materials
                Materials
                MDPI
                1996-1944
                27 February 2018
                March 2018
                : 11
                : 3
                : 347
                Affiliations
                [1 ]Engineering Research Center of Synthetic Resin and Special Fiber, Ministry of Education, Changchun University of Technology, Changchun 130012, China; 1201702002@ 123456stu.ccut.edu.cn (S.S.); 1201702004@ 123456stu.ccut.edu.cn (S.X.); 20142212@ 123456stu.ccut.edu.cn (S.J.); lvxue@ 123456ccut.edu.cn (X.L.)
                [2 ]Key Laboratory of Automobile Materials, College of Materials Science & Engineering, Jilin University, Changchun 130025, China
                Author notes
                [* ]Correspondence: sunshulin@ 123456ccut.edu.cn (S.S.); lqm@ 123456jlu.edu.cn (Q.L.); Tel.: +86-431-8571-6467 (S.S.)
                Article
                materials-11-00347
                10.3390/ma11030347
                5872926
                29495491
                72e3d078-0ed4-458e-b42e-992a03982503
                © 2018 by the authors.

                Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license ( http://creativecommons.org/licenses/by/4.0/).

                History
                : 18 January 2018
                : 22 February 2018
                Categories
                Article

                poly(vinylidene fluoride),mma-co-gma copolymer,dielectric constant,dielectric loss,dispersion

                Comments

                Comment on this article