An overview of electrode materials in microbial fuel cells

Carbon nanotubes (CNT) are an important new class of technological materials that have numerous novel and useful properties. The forecast increase in manufacture makes it likely that increasing human exposure will occur, and as a result, CNT are beginning to come under toxicological scrutiny. This review seeks to set out the toxicological paradigms applicable to the toxicity of inhaled CNT, building on the toxicological database on nanoparticles (NP) and fibers. Relevant workplace regulation regarding exposure is also considered in the light of our knowledge of CNT. CNT could have features of both NP and conventional fibers, and so the current paradigm for fiber toxicology, which is based on mineral fibers and synthetic vitreous fibers, is discussed. The NP toxicology paradigm is also discussed in relation to CNT. The available peer-reviewed literature suggests that CNT may have unusual toxicity properties. In particular, CNT seem to have a special ability to stimulate mesenchymal cell growth and to cause granuloma formation and fibrogenesis. In several studies, CNT have more adverse effects than the same mass of NP carbon and quartz, the latter a commonly used benchmark of particle toxicity. There is, however, no definitive inhalation study available that would avoid the potential for artifactual effects due to large mats and aggregates forming during instillation exposure procedures. Studies also show that CNT may exhibit some of their effects through oxidative stress and inflammation. CNT represent a group of particles that are growing in production and use, and therefore, research into their toxicology and safe use is warranted.

Microbial fuel cells (MFCs) have been used to produce electricity from different compounds, including acetate, lactate, and glucose. We demonstrate here that it is also possible to produce electricity in a MFC from domestic wastewater, while atthe same time accomplishing biological wastewater treatment (removal of chemical oxygen demand; COD). Tests were conducted using a single chamber microbial fuel cell (SCMFC) containing eight graphite electrodes (anodes) and a single air cathode. The system was operated under continuous flow conditions with primary clarifier effluent obtained from a local wastewater treatment plant. The prototype SCMFC reactor generated electrical power (maximum of 26 mW m(-2)) while removing up to 80% of the COD of the wastewater. Power output was proportional to the hydraulic retention time over a range of 3-33 h and to the influent wastewater strength over a range of 50-220 mg/L of COD. Current generation was controlled primarily by the efficiency of the cathode. Optimal cathode performance was obtained by allowing passive air flow rather than forced air flow (4.5-5.5 L/min). The Coulombic efficiency of the system, based on COD removal and current generation, was < 12% indicating a substantial fraction of the organic matter was lost without current generation. Bioreactors based on power generation in MFCs may represent a completely new approach to wastewater treatment. If power generation in these systems can be increased, MFC technology may provide a new method to offset wastewater treatment plant operating costs, making advanced wastewater treatment more affordable for both developing and industrialized nations.