1
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: not found
      • Article: not found

      OPTIMIZATION OF PROCESS PARAMETERS IN FUSED DEPOSITION MODELING USING WEIGHTED PRINCIPAL COMPONENT ANALYSIS

      , , ,
      Journal of Advanced Manufacturing Systems
      World Scientific Pub Co Pte Lt

      Read this article at

      ScienceOpenPublisher
      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Related collections

          Most cited references10

          • Record: found
          • Abstract: not found
          • Article: not found

          RAPID MANUFACTURING AND RAPID TOOLING WITH LAYER MANUFACTURING (LM) TECHNOLOGIES, STATE OF THE ART AND FUTURE PERSPECTIVES

            Bookmark
            • Record: found
            • Abstract: not found
            • Article: not found

            Critical parameters influencing the quality of prototypes in fused deposition modelling

              Bookmark
              • Record: found
              • Abstract: not found
              • Article: not found

              Effect of Layer Orientation on Mechanical Properties of Rapid Prototyped Samples

                Bookmark

                Author and article information

                Journal
                Journal of Advanced Manufacturing Systems
                J. Adv. Manuf. Syst.
                World Scientific Pub Co Pte Lt
                0219-6867
                1793-6896
                December 2011
                December 2011
                : 10
                : 02
                : 241-259
                Article
                10.1142/S0219686711002181
                8041ca29-3080-415d-a537-a25070b6a60f
                © 2011
                History

                Comments

                Comment on this article