30
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Development of a Redox-Label-Doped Molecularly Imprinted Polymer on β-Cyclodextrin/Reduced Graphene Oxide for Electrochemical Detection of a Stress Biomarker

      research-article
      ,
      ACS Omega
      American Chemical Society

      Read this article at

      ScienceOpenPublisherPMC
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Cortisol is a major stress biomarker involved in the regulation of metabolic and immune responses. Readily accessible assays with sufficient quantitative and temporal resolution can assist in prevention, early diagnosis, and management of chronic diseases. Whereas conventional assays are costly in terms of time, labor, and capital, an electrochemical approach offers the possibility of miniaturization and detection at the point-of-care. Here, we investigate the biosensor application of molecularly imprinted polypyrrole (PPy) doped with hexacyanoferrate (HCF) and coupled to reduced graphene oxide functionalized with β-cyclodextrin (β-CD). β-CD provides an inclusion site for lipophilic cortisol and was electrochemically grafted simultaneous with reduction of GO. Next, PPy was electrochemically deposited in presence of cortisol template with HCF dopant ions serving as intrinsic redox probe. Thus, the sensor response was evaluated via changes of redox peak current in cyclic voltammetry and demonstrated a broad logarithmic detection range (5 pg/mL to 5000 ng/mL, R 2 = 0.995), with a sensitivity of 8.809 μA log –1 (ng/mL) cm –2 and LOD of 19.3 pM. The sensor was shown to be specific toward cortisol in reference to salivary cortisol concentration in saliva over structural analogues. The sensor was exhibited to determine cortisol in artificial saliva at normal and elevated levels. The good performance and facile electrochemical fabrication of this antibody- and external label-free interface are promising for the development of affordable point-of-care biosensors.

          Related collections

          Most cited references53

          • Record: found
          • Abstract: found
          • Article: not found

          Salivary cortisol as a biomarker in stress research.

          Salivary cortisol is frequently used as a biomarker of psychological stress. However, psychobiological mechanisms, which trigger the hypothalamus-pituitary-adrenal axis (HPAA) can only indirectly be assessed by salivary cortisol measures. The different instances that control HPAA reactivity (hippocampus, hypothalamus, pituitary, adrenals) and their respective modulators, receptors, or binding proteins, may all affect salivary cortisol measures. Thus, a linear relationship with measures of plasma ACTH and cortisol in blood or urine does not necessarily exist. This is particularly true under response conditions. The present paper addresses several psychological and biological variables, which may account for such dissociations, and aims to help researchers to rate the validity and psychobiological significance of salivary cortisol as an HPAA biomarker of stress in their experiments.
            • Record: found
            • Abstract: found
            • Article: not found

            Graphene Oxide-Based Electrode Inks for 3D-Printed Lithium-Ion Batteries.

            All-component 3D-printed lithium-ion batteries are fabricated by printing graphene-oxide-based composite inks and solid-state gel polymer electrolyte. An entirely 3D-printed full cell features a high electrode mass loading of 18 mg cm(-2) , which is normalized to the overall area of the battery. This all-component printing can be extended to the fabrication of multidimensional/multiscale complex-structures of more energy-storage devices.
              • Record: found
              • Abstract: found
              • Article: found
              Is Open Access

              Molecularly selective nanoporous membrane-based wearable organic electrochemical device for noninvasive cortisol sensing

              A new wearable nanoporous organic electrochemical device used as a medical diagnostics tool for noninvasive hormone sensing.

                Author and article information

                Journal
                ACS Omega
                ACS Omega
                ao
                acsodf
                ACS Omega
                American Chemical Society
                2470-1343
                07 September 2022
                20 September 2022
                : 7
                : 37
                : 33491-33499
                Affiliations
                Department of Materials Engineering, School of Engineering, The University of Tokyo , 7-3-1 Hongo, Bunkyo-ku, Tokyo 113-8656, Japan
                Author notes
                [* ]Email: sakata@ 123456biofet.t.u-tokyo.ac.jp . Phone: +81-3-5841-1842. Fax: +81-3-5841-1842.
                Author information
                https://orcid.org/0000-0003-1246-5000
                Article
                10.1021/acsomega.2c04423
                9494674
                36157772
                8999faa3-8b9c-4cba-907a-b6da146e1753
                © 2022 The Authors. Published by American Chemical Society

                Permits non-commercial access and re-use, provided that author attribution and integrity are maintained; but does not permit creation of adaptations or other derivative works ( https://creativecommons.org/licenses/by-nc-nd/4.0/).

                History
                : 13 July 2022
                : 26 August 2022
                Funding
                Funded by: Program on Open Innovation Platform with Enterprises, Research Institute and Academia, doi 10.13039/501100009035;
                Award ID: NA
                Categories
                Article
                Custom metadata
                ao2c04423
                ao2c04423

                Comments

                Comment on this article

                Related Documents Log