9
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Rapid Growth of Nanocrystalline Diamond on Single Crystal Diamond for Studies on Materials under Extreme Conditions

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Early stage nucleation morphologies of spatially localized nanocrystalline diamond (NCD) micro-anvils grown on (100)-oriented single crystal diamond (SCD) anvil surfaces were analyzed and investigated for applications in high pressure studies on materials. NCD was grown on SCD using Microwave Plasma Chemical Vapor Deposition (MPCVD) for brief time intervals ranging from 1–15 minutes. Early stage film morphologies were characterized using scanning electron microscopy (SEM) and Raman spectroscopy and were compared to films grown for several hours. Rapid nucleation and growth of NCD on SCD is demonstrated without any pre-growth seeding of the substrate surface. As grown NCD diamond micro-anvils on SCD were used to generate static pressure of 0.5 Terapascal (TPa) on a tungsten sample as measured by synchrotron x-ray diffraction in a diamond anvil cell. Atomic force microscopy (AFM) analysis after decompression from ultrahigh pressures showed that the detachment of the NCD stage occurred in the bulk of the SCD and not at the interface, suggesting significant adhesive bond strength between nanocrystalline and single crystal diamond.

          Related collections

          Most cited references18

          • Record: found
          • Abstract: not found
          • Article: not found

          Finite Elastic Strain of Cubic Crystals

            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Raman spectroscopy of amorphous, nanostructured, diamond-like carbon, and nanodiamond.

            Raman spectroscopy is a standard characterization technique for any carbon system. Here we review the Raman spectra of amorphous, nanostructured, diamond-like carbon and nanodiamond. We show how to use resonant Raman spectroscopy to determine structure and composition of carbon films with and without nitrogen. The measured spectra change with varying excitation energy. By visible and ultraviolet excitation measurements, the G peak dispersion can be derived and correlated with key parameters, such as density, sp(3) content, elastic constants and chemical composition. We then discuss the assignment of the peaks at 1150 and 1480 cm(-1) often observed in nanodiamond. We review the resonant Raman, isotope substitution and annealing experiments, which lead to the assignment of these peaks to trans-polyacetylene.
              Bookmark
              • Record: found
              • Abstract: not found
              • Article: not found

              Enhanced diamond nucleation on monodispersed nanocrystalline diamond

                Bookmark

                Author and article information

                Contributors
                ykvohra@uab.edu
                Journal
                Sci Rep
                Sci Rep
                Scientific Reports
                Nature Publishing Group UK (London )
                2045-2322
                23 January 2018
                23 January 2018
                2018
                : 8
                : 1402
                Affiliations
                ISNI 0000000106344187, GRID grid.265892.2, Department of Physics, , University of Alabama at Birmingham, ; Birmingham, Alabama 35294 USA
                Article
                19915
                10.1038/s41598-018-19915-9
                5780477
                29362393
                990f443a-1d96-472e-bc37-0f2d35acee27
                © The Author(s) 2018

                Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made. The images or other third party material in this article are included in the article’s Creative Commons license, unless indicated otherwise in a credit line to the material. If material is not included in the article’s Creative Commons license and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this license, visit http://creativecommons.org/licenses/by/4.0/.

                History
                : 10 May 2017
                : 10 January 2018
                Categories
                Article
                Custom metadata
                © The Author(s) 2018

                Uncategorized
                Uncategorized

                Comments

                Comment on this article