7
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: not found

      Coherent optical clock down-conversion for microwave frequencies with 10−18 instability

      Read this article at

      ScienceOpenPublisherPubMed
      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Optical atomic clocks are poised to redefine the Système International (SI) second, thanks to stability and accuracy more than 100 times better than the current microwave atomic clock standard. However, the best optical clocks have not seen their performance transferred to the electronic domain, where radar, navigation, communications, and fundamental research rely on less stable microwave sources. By comparing two independent optical-to-electronic signal generators, we demonstrate a 10-gigahertz microwave signal with phase that exactly tracks that of the optical clock phase from which it is derived, yielding an absolute fractional frequency instability of 1 × 10 −18 in the electronic domain. Such faithful reproduction of the optical clock phase expands the opportunities for optical clocks both technologically and scientifically for time dissemination, navigation, and long-baseline interferometric imaging.

          Related collections

          Most cited references38

          • Record: found
          • Abstract: not found
          • Article: not found

          Laser phase and frequency stabilization using an optical resonator

            Bookmark
            • Record: found
            • Abstract: not found
            • Article: not found

            The CORDIC Trigonometric Computing Technique

              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Delivering the same optical frequency at two places: accurate cancellation of phase noise introduced by an optical fiber or other time-varying path.

              Although a single-mode optical fiber is a convenient and efficient interface/connecting medium, it introduces phase-noise modulation, which corrupts high-precision frequency-based applications by broadening the spectrum toward the kilohertz domain. We describe a simple double-pass fiber noise measurement and control system, which is demonstrated to provide millihertz accuracy of noise cancellation.
                Bookmark

                Author and article information

                Journal
                Science
                Science
                American Association for the Advancement of Science (AAAS)
                0036-8075
                1095-9203
                May 21 2020
                May 22 2020
                May 21 2020
                May 22 2020
                : 368
                : 6493
                : 889-892
                Affiliations
                [1 ]Time and Frequency Division, National Institute of Standards and Technology, 325 Broadway, Boulder, CO 80305, USA.
                [2 ]Department of Physics, University of Colorado Boulder, 440 UCB, Boulder, CO 80309, USA.
                [3 ]Department of Electrical and Computer Engineering, University of Virginia, Charlottesville, VA 22904, USA.
                Article
                10.1126/science.abb2473
                32439794
                b6413bb9-0dd7-4b20-9491-3a5f18421f66
                © 2020

                http://www.sciencemag.org/about/science-licenses-journal-article-reuse

                History

                Comments

                Comment on this article