Blog
About

9
views
0
recommends
+1 Recommend
1 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found

      Effect of the heating rate in the tempering of DIN 100 V1 Translated title: Einfluss der Heizrate auf das Anlassen des Stahls DIN 100 V1

      Read this article at

      ScienceOpenPublisher
      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          In this paper, the effect of the heating rate on the process of tempering and the obtained hardness of the DIN 100 V1 (AISI W2) carbon tool steel has been investigated and determined. Steel specimens in two initial states were investigated: after quenching and after quenching and deep-cryogenic cooling. The specimens were submitted to tempering in a dilatometer, varying the heating rates, temperature of tempering between 200°C and 690°C and duration of keeping the specimens at that temperature. A common effect of these factors on the temperature of the start of particular stages in tempering and the obtained properties was determined using dilatometry. Differential dilatation analysis was carried out, together with hardness tests and XRD (X-ray diffraction) analysis.

          Kurzfassung

          In diesem Artikel wird die Auswirkung der Erwärmgeschwindigkeit auf den Anlassprozess und die Härte des unlegierten Werkzeugstahles DIN 100 V1 (AISI W2) untersucht und bestimmt. Die Stahlproben wurden im abgeschreckten sowie im abgeschreckten und tiefgekühlten Zustand untersucht. Diese Proben wurden in einem Dilatometer mit verschiedenen Erwärmgeschwindigkeiten, Anlassdauern und -temperaturen zwischen 200°C und 690°C angelassen. Die gemeinsame Wirkung dieser Faktoren auf die Temperaturen, bei denen die jeweiligen einzelnen Stufen des Anlassens einsetzen und die daraus resultierenden Eigenschaften wurden mittels Differenzial-Dilatation-Analyse, Härtemessungen und röntgenographischer Methoden untersucht.

          Related collections

          Most cited references 15

          • Record: found
          • Abstract: not found
          • Article: not found

          Steels: Processing, Structure and Performance

           G KRAUSS,  G Krauss (2005)
            Bookmark
            • Record: found
            • Abstract: not found
            • Article: not found

            Calibration of the differential dilatometric measurement signal upon heating and cooling thermal expansion of pure iron

              Bookmark
              • Record: found
              • Abstract: not found
              • Article: not found

              Dilatometric analysis of phase transformations in hypo-eutectoid steels

                Bookmark

                Author and article information

                Journal
                htme
                HTM Journal of Heat Treatment and Materials
                Carl Hanser Verlag
                1867-2493
                2194-1831
                2012
                : 67
                : 2
                : 118-124
                Affiliations
                1 Assistant Professor, Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Croatia; darko.landek@ 123456fsb.hr
                2 Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Croatia
                Article
                HT110145
                10.3139/105.110145
                © 2012, Carl Hanser Verlag, München
                Page count
                References: 16, Pages: 7
                Product
                Self URI (journal page): http://www.hanser-elibrary.com/loi/htme
                Categories
                Fachbeiträge/Technical Contributions

                Comments

                Comment on this article