Blog
About

  • Record: found
  • Abstract: found
  • Article: found
Is Open Access

An investigation the effects of geometric tolerances on the natural frequencies of rotating shafts

Read this article at

ScienceOpenPublisherDOAJ
Bookmark
      There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

      Abstract

      This paper presents the effects of geometric tolerances on the rotating shafts natural frequencies. Due to modeling the tolerances, a code is written in MATLAB 2013 software that produces deviated points. Deviated points are controlled by different geometric tolerances, including cylindricity, total run-out and coaxiality tolerances. Final surfaces and models passing through the points are created using SolidWorks 2013 software and finally modal analysis is carried out with the FE software. It is observed whatever the natural frequency is higher or the geometric tolerances are greater, the real and ideal shafts natural frequencies are more distant. Also difference percentage between ideal and real frequencies is investigated. The results show that the percentage value is approximately constant for every mode shapes.

      Related collections

      Author and article information

      Journal
      Journal of Applied and Computational Mechanics
      Shahid Chamran University of Ahvaz
      01 April 2015
      : 1
      : 2
      325ab81ea67f4855985f923e19194802

      This work is licensed under a Creative Commons Attribution Non Commercial 4.0 Unported License. To view a copy of this license, visit http://creativecommons.org/licenses/by-nc/4.0/legalcode

      Product
      Self URI (journal page): http://jacm.scu.ac.ir/
      Categories
      Mechanics of engineering. Applied mechanics
      TA349-359

      Comments

      Comment on this article