11
views
0
recommends
+1 Recommend
1 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Properties of concrete manufactured with use of ceramic sanitary ware waste as aggregate Translated title: Propriedades do concreto fabricado com resíduo de louça sanitaria como agregado

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          ABSTRACT In concrete manufacture, cement (Portland type is the most used), water and aggregates (classified into coarse and fine) are used. With the use of several raw materials the generation of waste is inevitable, both in construction and in other sectors, such as the industries producing ceramic materials. Among the types of waste from such industries, can be mentioned the ceramic scrap (from the sanitary ware industry). According to the above, the aim of this research was to study the addition of ceramic scrap as a coarse aggregate in different proportions in the concrete formulation. In order to do this, was select wastes from an industry in the south of Minas Gerais (Brazil), and prepare specimens to determine the fresh (slump test, adhesiveness and porosity) and hardened (compression strength) of concrete. Were fabricated five concrete formulations, one reference (RC) and four with ceramic scrap substituted for coarse aggregate in the proportions of 25% (CSC-I), 50% (CSC-II), 75% (CSC-III) and 100% (CSC -IV). Fresh concretes, two formulations did not show adhesiveness (CSC-III and CSC-IV) and two a small water runoff (CSC-I and CSC-II), however, without compromising the concrete’s workability. Regarding the compression strength, the average values presented were very good, including the formulation with 100% ceramic scrap (fc = 47.78 MPa). Another important aspect observed in the rupture modes was the small adhesion between the ceramic scrap and the mortar due to the glazing in the contour of the waste. As for the porosity of the concretes, those with 25%, 75% and 100% of ceramic scrap in their composition presented lower values than the reference concrete.

          Translated abstract

          RESUMO Na fabricação do concreto, cimento (o Portland é o mais usado), água e agregados (classificados em finos e grossos), são usados. Com a utilização de inúmeras matérias-primas, a geração de resíduos é inevitável, seja na construção civil ou em outros setores, como as indústrias produtoras de materiais cerâmicos. Entre os tipos de resíduos destas indústrias, pode ser mencionado o scrap cerâmico (proveniente da indústria de louças sanitárias). Sendo assim, o objetivo deste trabalho foi estudar a adição de scrap cerâmicso como agregado graúdo em diferentes proporções na formulação de concretos. Para isso, foram selecionados resíduos de uma indústria do sul de Minas Gerais, e foram preparados corpos de prova para determinação das propriedades do concreto fresco (slump teste, segregação e porosidade) e endurecido (resistência à compressão) das diferentes formulações do concreto. Foram confeccionadas 5 diferentes formulações, uma de referência (CR) e quatro com resíduo cerâmico como substituinte do agregado graúdo nas proporções de 25% (CSC-I), 50% (CSC-II), 75% (CSC-III) and 100% (CSC -IV). Em relação aos concretos frescos, duas formulações não apresentaram segregação (CSC-III and CSC-IV) e duas um pequeno escorrimento de água (CSC-I and CSC-II ), entretanto, em comprometer a trabalhabilidade do concreto. Em relação às resistência à compressão, os valores médios apresentados foram satisfatórios, incluindo a formulação com 100% de scrap cerâmico (fc = 47.78 MPa). Outro importante aspecto observado nos modos de ruptura dos corpos de prova foi a pequena adesão entre o resíduo de louça sanitária e a argamassa devido à camada de esmalte no contorno do resíduo. Em relação à porosidade das formulações, aquelas com 25, 75 e 100% de resíduo apresentaram valores mais baixos em relação ao concreto de referência.

          Related collections

          Most cited references21

          • Record: found
          • Abstract: not found
          • Article: not found

          Using ceramic sanitary ware waste as concrete aggregate

            Bookmark
            • Record: found
            • Abstract: not found
            • Article: not found

            Effects of Fe2O3 Nanoparticles on Water Permeability and Strength Assessments of High Strength Self-Compacting Concrete

              Bookmark
              • Record: found
              • Abstract: not found
              • Article: not found

              Mechanical properties of the concrete containing recycled fibers and aggregates

                Bookmark

                Author and article information

                Contributors
                Role: ND
                Role: ND
                Role: ND
                Role: ND
                Journal
                rmat
                Matéria (Rio de Janeiro)
                Matéria (Rio J.)
                Rede Latino-Americana de Materiais (Rio de Janeiro, RJ, Brazil )
                1517-7076
                2019
                : 24
                : 2
                : e12350
                Affiliations
                [02] Pouso Alegre Minas Gerais orgnameInstituto Federal do Sul de Minas (IFSUL de Minas) orgdiv1Departamento de Engenharia Civil Brasil
                [01] Porto Velho Rondônia orgnameUniversidade Federal de Rondônia (UNIR) orgdiv1Departamento de Engenharia Civil (DECIV) Brasil
                [03] Poços de Caldas Minas Gerais orgnameUniversidade Federal de Alfenas (UNIFAL) orgdiv1Programa de Pós-Graduação em Ciência e Engenharia de Materiais (PPGCEM) Brasil
                Article
                S1517-70762019000200310
                10.1590/s1517-707620190002.0665
                ce71dfb0-893b-458c-81ea-1acf1ed61bc2

                This work is licensed under a Creative Commons Attribution 4.0 International License.

                History
                : 26 January 2018
                : 28 June 2018
                Page count
                Figures: 0, Tables: 0, Equations: 0, References: 38, Pages: 0
                Product

                SciELO Brazil

                Categories
                Articles

                Waste,Mechanical properties,Concreto,Propriedades mecânicas,Resíduo,Scrap cerâmico,Ceramic scrap,Concrete

                Comments

                Comment on this article