Glyco-DIA: a method for quantitative O-glycoproteomics with in silico-boosted glycopeptide libraries

An algorithm for the assignment of phosphorylation sites in peptides is described. The program uses tandem mass spectrometry data in conjunction with the respective peptide sequences to calculate site probabilities for all potential phosphorylation sites. Tandem mass spectra from synthetic phosphopeptides were used for optimization of the scoring parameters employing all commonly used fragmentation techniques. Calculation of probabilities was adapted to the different fragmentation methods and to the maximum mass deviation of the analysis. The software includes a novel approach to peak extraction, required for matching experimental data to the theoretical values of all isoforms, by defining individual peak depths for the different regions of the tandem mass spectrum. Mixtures of synthetic phosphopeptides were used to validate the program by calculation of its false localization rate versus site probability cutoff characteristic. Notably, the empirical obtained precision was higher than indicated by the applied probability cutoff. In addition, the performance of the algorithm was compared to existing approaches to site localization such as Ascore. In order to assess the practical applicability of the algorithm to large data sets, phosphopeptides from a biological sample were analyzed, localizing more than 3000 nonredundant phosphorylation sites. Finally, the results obtained for the different fragmentation methods and localization tools were compared and discussed.

Abstract Many research questions in fields such as personalized medicine, drug screens or systems biology depend on obtaining consistent and quantitatively accurate proteomics data from many samples. SWATH‐MS is a specific variant of data‐independent acquisition (DIA) methods and is emerging as a technology that combines deep proteome coverage capabilities with quantitative consistency and accuracy. In a SWATH‐MS measurement, all ionized peptides of a given sample that fall within a specified mass range are fragmented in a systematic and unbiased fashion using rather large precursor isolation windows. To analyse SWATH‐MS data, a strategy based on peptide‐centric scoring has been established, which typically requires prior knowledge about the chromatographic and mass spectrometric behaviour of peptides of interest in the form of spectral libraries and peptide query parameters. This tutorial provides guidelines on how to set up and plan a SWATH‐MS experiment, how to perform the mass spectrometric measurement and how to analyse SWATH‐MS data using peptide‐centric scoring. Furthermore, concepts on how to improve SWATH‐MS data acquisition, potential trade‐offs of parameter settings and alternative data analysis strategies are discussed.

To take advantage of the potential quantitative benefits offered by tandem mass spectrometry, we have modified the method in which tandem mass spectrum data are acquired in 'shotgun' proteomic analyses. The proposed method is not data dependent and is based on the sequential isolation and fragmentation of precursor windows (of 10 m/z) within the ion trap until a desired mass range has been covered. We compared the quantitative figures of merit for this method to those for existing strategies by performing an analysis of the soluble fraction of whole-cell lysates from yeast metabolically labeled in vivo with (15)N. To automate this analysis, we modified software (RelEx) previously written in the Yates lab to generate chromatograms directly from tandem mass spectra. These chromatograms showed improvements in signal-to-noise ratio of approximately three- to fivefold over corresponding chromatograms generated from mass spectrometry scans. In addition, to demonstrate the utility of the data-independent acquisition strategy coupled with chromatogram reconstruction from tandem mass spectra, we measured protein expression levels in two developmental stages of Caenorhabditis elegans.