Microbial challenge test of a novel epoprostenol sodium formulation

Abstract

Aim

The aim of the current study was to present a comprehensive display of antimicrobial activity of a novel epoprostenol sodium formulation with respect to seven different microorganisms, two levels of inoculation (10 ²–10 ³ colony forming units [CFU]/mL and 10 ⁵–10 ⁶ CFU/mL), two diluents (sterile water for injection [SWI] and sterile saline [sodium chloride 0.9%] for injection [SSI]), two concentrations (3,000 ng/mL and 15,000 ng/mL), and seven different storage time points at two temperatures (up to 10 days at 2°C–8°C and 20°C–25°C).

Materials and methods

Antimicrobial activity was evaluated for, 1) solutions at 3,000 ng/mL inoculated with 10 ²–10 ³ CFU/mL and 10 ⁵–10 ⁶ CFU/mL; and 2) solutions at 15,000 ng/mL inoculated with 10 ²–10 ³ CFU/mL and 10 ⁵–10 ⁶ CFU/mL. All solutions were stored for up to 10 days at 2°C–8°C and 20°C–25°C. Solutions were prepared by reconstitution and further dilution of an epoprostenol sodium formulation using SWI or SSI. Antimicrobial activity was measured after inoculation with seven species of bacteria, yeast, and mold.

Results

For all solutions, after 10 days, no microbial growth with respect to initial inoculum was observed, with the exception of a few early time points when using SWI as diluent. Some microorganisms died off completely, whereas others remained stable overall or returned to initial levels. Prior to decreasing, some microorganisms displayed a slight initial increase, presumed to be caused by breakup of clusters. Storage temperature had a negligible influence on the results, whereas choice of diluent (SSI or SWI) impacted growth kinetics in that SSI had a greater antimicrobial effect than SWI.

Conclusion

Upon reconstitution and further dilution of the novel epoprostenol formulation to concentrations of 3,000 ng/mL and 15,000 ng/mL with SWI or SSI, the resulting solutions did not support growth of the tested microorganisms when stored at 2°C–8°C or 20°C–25°C for up to 10 days.