12
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      A High Power, Frequency Tunable Colloidal Quantum Dot (CdSe/ZnS) Laser

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Tunable lasers are essential for medical, engineering and basic science research studies. Most conventional solid-state lasers are capable of producing a few million laser shots, but limited to specific wavelengths, which are bulky and very expensive. Dye lasers are continuously tunable, but exhibit very poor chemical stability. As new tunable, efficient lasers are always in demand, one such laser is designed with various sized CdSe/ZnS quantum dots. They were used as a colloid in tetrahydrofuran to produce a fluorescent broadband emission from 520 nm to 630 nm. The second (532 nm) and/or third harmonic (355 nm) of the Nd:YAG laser (10 ns, 10 Hz) were used together as the pump source. In this study, different sized quantum dots were independently optically pumped to produce amplified spontaneous emission (ASE) with 4 nm to 7 nm of full width at half-maximum (FWHM), when the pump power and focusing were carefully optimized. The beam was directional with a 7 mrad divergence. Subsequently, these quantum dots were combined together, and the solution was placed in a resonator cavity to obtain a laser with a spectral width of 1 nm and tunable from 510 to 630 nm, with a conversion efficiency of about 0.1%.

          Related collections

          Most cited references24

          • Record: found
          • Abstract: found
          • Article: not found

          Monodisperse FePt nanoparticles and ferromagnetic FePt nanocrystal superlattices

          Sun, Murray, Weller (2000)
          Synthesis of monodisperse iron-platinum (FePt) nanoparticles by reduction of platinum acetylacetonate and decomposition of iron pentacarbonyl in the presence of oleic acid and oleyl amine stabilizers is reported. The FePt particle composition is readily controlled, and the size is tunable from 3- to 10-nanometer diameter with a standard deviation of less than 5%. These nanoparticles self-assemble into three-dimensional superlattices. Thermal annealing converts the internal particle structure from a chemically disordered face-centered cubic phase to the chemically ordered face-centered tetragonal phase and transforms the nanoparticle superlattices into ferromagnetic nanocrystal assemblies. These assemblies are chemically and mechanically robust and can support high-density magnetization reversal transitions.
            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Shape control of CdSe nanocrystals

            Peng, Manna, Yang (2000)
            Nanometre-size inorganic dots, tubes and wires exhibit a wide range of electrical and optical properties that depend sensitively on both size and shape, and are of both fundamental and technological interest. In contrast to the syntheses of zero-dimensional systems, existing preparations of one-dimensional systems often yield networks of tubes or rods which are difficult to separate. And, in the case of optically active II-VI and III-V semiconductors, the resulting rod diameters are too large to exhibit quantum confinement effects. Thus, except for some metal nanocrystals, there are no methods of preparation that yield soluble and monodisperse particles that are quantum-confined in two of their dimensions. For semiconductors, a benchmark preparation is the growth of nearly spherical II-VI and III-V nanocrystals by injection of precursor molecules into a hot surfactant. Here we demonstrate that control of the growth kinetics of the II-VI semiconductor cadmium selenide can be used to vary the shapes of the resulting particles from a nearly spherical morphology to a rod-like one, with aspect ratios as large as ten to one. This method should be useful, not only for testing theories of quantum confinement, but also for obtaining particles with spectroscopic properties that could prove advantageous in biological labelling experiments and as chromophores in light-emitting diodes.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Ultrasensitive solution-cast quantum dot photodetectors.

              Solution-processed electronic and optoelectronic devices offer low cost, large device area, physical flexibility and convenient materials integration compared to conventional epitaxially grown, lattice-matched, crystalline semiconductor devices. Although the electronic or optoelectronic performance of these solution-processed devices is typically inferior to that of those fabricated by conventional routes, this can be tolerated for some applications in view of the other benefits. Here we report the fabrication of solution-processed infrared photodetectors that are superior in their normalized detectivity (D*, the figure of merit for detector sensitivity) to the best epitaxially grown devices operating at room temperature. We produced the devices in a single solution-processing step, overcoating a prefabricated planar electrode array with an unpatterned layer of PbS colloidal quantum dot nanocrystals. The devices showed large photoconductive gains with responsivities greater than 10(3) A W(-1). The best devices exhibited a normalized detectivity D* of 1.8 x 10(13) jones (1 jones = 1 cm Hz(1/2) W(-1)) at 1.3 microm at room temperature: today's highest performance infrared photodetectors are photovoltaic devices made from epitaxially grown InGaAs that exhibit peak D* in the 10(12) jones range at room temperature, whereas the previous record for D* from a photoconductive detector lies at 10(11) jones. The tailored selection of absorption onset energy through the quantum size effect, combined with deliberate engineering of the sequence of nanoparticle fusing and surface trap functionalization, underlie the superior performance achieved in this readily fabricated family of devices.
                Bookmark

                Author and article information

                Contributors
                Role: Academic Editor
                Journal
                Nanomaterials (Basel)
                Nanomaterials (Basel)
                nanomaterials
                Nanomaterials
                MDPI
                2079-4991
                30 January 2017
                February 2017
                : 7
                : 2
                : 29
                Affiliations
                [1 ]Research Chair on laser diagnosis of cancers, College of Science, King Saud University, 11451 Riyadh, Saudi Arabia; srajendra@ 123456ksu.edu.sa (S.P.); hanan-laser@ 123456hotmail.com (H.S.A.); malsalhi@ 123456ksu.edu.sa (M.S.A.)
                [2 ]Department of Physics and Astronomy, College of Science, King Saud University, 11451 Riyadh, Saudi Arabia
                [3 ]Department of Electrical and Electronics, College of Engineering, Kalasalingam University, Anand Nagar, Krishnankoil, Virudhunagar 626190, Tamil Nadu, India; deva230@ 123456yahoo.com
                Author notes
                [* ]Correspondence: mvadivel@ 123456ksu.edu.sa ; Tel.: +966-563-405-408
                Article
                nanomaterials-07-00029
                10.3390/nano7020029
                5333014
                30d66edf-c1d0-4de1-8dd2-2990db6f68f1
                © 2017 by the authors.

                Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license ( http://creativecommons.org/licenses/by/4.0/).

                History
                : 06 December 2016
                : 24 January 2017
                Categories
                Article

                quantum dots cdse/zns,amplified spontaneous emission,spectral properties,broad tunable laser from 520 to 630 nm,42.70.hj,85.35.ben,2.60.-v,42.60.-v

                Comments

                Comment on this article