Blog
About

6
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      An Alternate Method to Springback Compensation for Sheet Metal Forming

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          The aim of this work is to improve the accuracy of cold stamping product by accommodating springback. This is a numerical approach to improve the accuracy of springback analysis and die compensation process combining the displacement adjustment (DA) method and the spring forward (SF) algorithm. This alternate hybrid method (HM) is conducted by firstly employing DA method followed by the SF method instead of either DA or SF method individually. The springback shape and the target part are used to optimize the die surfaces compensating springback. The hybrid method (HM) algorithm has been coded in Fortran and tested in two- and three-dimensional models. By implementing the HM, the springback error can be decreased and the dimensional deviation falls in the predefined tolerance range.

          Related collections

          Most cited references 57

          • Record: found
          • Abstract: not found
          • Article: not found

          Fundamentals of Modern Manufacturing: Materials Processes, and Systems

            Bookmark
            • Record: found
            • Abstract: not found
            • Article: not found

            Multi-objective optimization of sheet metal forming process using Pareto-based genetic algorithm

             Liu Wei,  Yang Yuying (2008)
              Bookmark
              • Record: found
              • Abstract: not found
              • Article: not found

              Advanced Issues in springback

                Bookmark

                Author and article information

                Journal
                ScientificWorldJournal
                ScientificWorldJournal
                TSWJ
                The Scientific World Journal
                Hindawi Publishing Corporation
                2356-6140
                1537-744X
                2014
                11 June 2014
                : 2014
                Affiliations
                1Department of Engineering Mechanics, Universiti Tun Hussein Onn Malaysia, Parit Raja, Batu Pahat, 86400 Johor, Malaysia
                2Department of Mechanical Engineering, Muhammadiyah University of Surakarta, Pabelan, Kartasura 57162, Indonesia
                3Department of Materials Engineering and Design, Universiti Tun Hussein Onn Malaysia, Parit Raja, 86400 Johor, Malaysia
                4Faculty of Forestry, Universiti Putra Malaysia, Serdang, 43400 Selangor, Malaysia
                Author notes
                *Waluyo Adi Siswanto: waluyo@ 123456uthm.edu.my

                Academic Editor: Hailiang Yu

                Article
                10.1155/2014/301271
                4140107
                Copyright © 2014 Waluyo Adi Siswanto et al.

                This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

                Categories
                Research Article

                Uncategorized

                Comments

                Comment on this article