Photocatalytic transformation of the antipsychotic drug risperidone in aqueous media on reduced graphene oxide—TiO 2 composites

Herein we obtained a chemically bonded TiO(2) (P25)-graphene nanocomposite photocatalyst with graphene oxide and P25, using a facile one-step hydrothermal method. During the hydrothermal reaction, both of the reduction of graphene oxide and loading of P25 were achieved. The as-prepared P25-graphene photocatalyst possessed great adsorptivity of dyes, extended light absorption range, and efficient charge separation properties simultaneously, which was rarely reported in other TiO(2)-carbon photocatalysts. Hence, in the photodegradation of methylene blue, a significant enhancement in the reaction rate was observed with P25-graphene, compared to the bare P25 and P25-CNTs with the same carbon content. Overall, this work could provide new insights into the fabrication of a TiO(2)-carbon composite as high performance photocatalysts and facilitate their application in the environmental protection issues.

The production of H(2) by photocatalytic water splitting has attracted a lot attention as a clean and renewable solar H(2) generation system. Despite tremendous efforts, the present great challenge in materials science is to develop highly active photocatalysts for splitting of water at low cost. Here we report a new composite material consisting of TiO(2) nanocrystals grown in the presence of a layered MoS(2)/graphene hybrid as a high-performance photocatalyst for H(2) evolution. This composite material was prepared by a two-step simple hydrothermal process using sodium molybdate, thiourea, and graphene oxide as precursors of the MoS(2)/graphene hybrid and tetrabutylorthotitanate as the titanium precursor. Even without a noble-metal cocatalyst, the TiO(2)/MoS(2)/graphene composite reaches a high H(2) production rate of 165.3 μmol h(-1) when the content of the MoS(2)/graphene cocatalyst is 0.5 wt % and the content of graphene in this cocatalyst is 5.0 wt %, and the apparent quantum efficiency reaches 9.7% at 365 nm. This unusual photocatalytic activity arises from the positive synergetic effect between the MoS(2) and graphene components in this hybrid cocatalyst, which serve as an electron collector and a source of active adsorption sites, respectively. This study presents an inexpensive photocatalyst for energy conversion to achieve highly efficient H(2) evolution without noble metals. © 2012 American Chemical Society

The nanocomposites of TiO(2)-graphene (TiO(2)-GR) have been prepared via a facile hydrothermal reaction of graphene oxide and TiO(2) in an ethanol-water solvent. We show that such a TiO(2)-GR nanocomposite exhibits much higher photocatalytic activity and stability than bare TiO(2) toward the gas-phase degradation of benzene, a volatile aromatic pollutant in air. By investigating the effect of different addition ratios of graphene on the photocatalytic activity of TiO(2)-GR systematically, we find that the higher weight ratio in TiO(2)-GR will decrease the photocatalytic activity. Analogous phenomenon is also observed for the liquid-phase degradation of dyes over TiO(2)-GR. In addition, the key features for TiO(2)-GR including enhancement of adsorptivity of pollutants, light absorption intensity, electron-hole pairs lifetime, and extended light absorption range have also been found in the composite of TiO(2) and carbon nanotubes (TiO(2)-CNT). These strongly manifest that TiO(2)-GR is in essence the same as other TiO(2)-carbon (carbon nanotubes, fullerenes, and activated carbon) composite materials on enhancement of photocatalytic activity of TiO(2), although graphene by itself has unique structural and electronic properties. Notably, this key fundamental question remains completely unaddressed in a recent report ( ACS Nano 2010 , 4 , 380 ) regarding liquid-phase degradation of dyes over the TiO(2)-GR photocatalyst. Thus, we propose that TiO(2)-GR cannot provide truly new insights into the fabrication of TiO(2)-carbon composite as high-performance photocatalysts. It is hoped that our work could avert the misleading message to the readership, hence offering a valuable source of reference on fabricating TiO(2)-carbon composites for their application as a photocatalyst in the environment cleanup.