Impact of pedestal density gradient and collisionality on ELM dynamics

Abstract

BOUT++ turbulence simulations are conducted to capture the underlying physics of the small ELM characteristics achieved by increasing separatrix density via controlling strike points from vertical to horizontal divertor plates for three EAST discharges. BOUT ++ linear simulations show that the most unstable modes change from high-n ideal ballooning modes to the intermediate-n peeling-ballooning modes and eventually to peeling-ballooning stable plasmas in the pedestal. Nonlinear simulations show that the fluctuation is saturated at a high level for the lowest separatrix density. The elm size decreases with increasing the separatrix density, which becomes less than 1%, leading to small ELMs. Simulations for three EAST discharges indicate that small ELMs can be triggered either by the marginally peeling-ballooning instability near the peak pressure gradient position inside pedestal or by a local instability in the pedestal foot with a larger separatrix density gradient. The pedestal collisionality scan for type-I ELMs with steep pedestal density gradient shows that both linear growth rate and elm size decrease with collisionality increasing. While the pedestal collisionality and pedestal density width scan with a weak pedestal density gradient indicate small ELMs can either be triggered by high-n ballooning mode or by low-n peeling mode in low collisionality region 0.04~0.1. The simulations indicate the weaker the linear unstable modes near marginal stability with small linear growth rate, the lower nonlinearly saturated fluctuation intensity and the smaller the turbulence spreading from the linear unstable region to stable regions in the nonlinear saturation phase, leading to small ELMs.