O-vacancy as the origin of negative bias illumination stress instability
  in amorphous In-Ga-Zn-O thin film transistors

There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

Abstract

We find that O-vacancy (Vo) acts as a hole trap and play a role in negative bias illumination stress instability in amorphous In-Ga-Zn-O thin film transistors. Photo-excited holes drifted toward the channel/dielectric interface due to small potential barriers and can be captured by Vo in the dielectrics. While Vo(+2) defects are very stable at room temperature, their original deep states are recovered via electron capture upon annealing. We also find that Vo(+2) can diffuse in amorphous phase, including hole accumulation near the interface under negative gate bias.

Related collections

Most cited references 4

Record: found
Abstract: found
Article: not found

Room-temperature fabrication of transparent flexible thin-film transistors using amorphous oxide semiconductors.

Kenji Nomura, Hiromichi Ohta, Akihiro Takagi … (2004)

Transparent electronic devices formed on flexible substrates are expected to meet emerging technological demands where silicon-based electronics cannot provide a solution. Examples of active flexible applications include paper displays and wearable computers. So far, mainly flexible devices based on hydrogenated amorphous silicon (a-Si:H) and organic semiconductors have been investigated. However, the performance of these devices has been insufficient for use as transistors in practical computers and current-driven organic light-emitting diode displays. Fabricating high-performance devices is challenging, owing to a trade-off between processing temperature and device performance. Here, we propose to solve this problem by using a novel semiconducting material--namely, a transparent amorphous oxide semiconductor from the In-Ga-Zn-O system (a-IGZO)--for the active channel in transparent thin-film transistors (TTFTs). The a-IGZO is deposited on polyethylene terephthalate at room temperature and exhibits Hall effect mobilities exceeding 10 cm2 V(-1) s(-1), which is an order of magnitude larger than for hydrogenated amorphous silicon. TTFTs fabricated on polyethylene terephthalate sheets exhibit saturation mobilities of 6-9 cm2 V(-1) s(-1), and device characteristics are stable during repetitive bending of the TTFT sheet.