Pb ₂BiS ₂I ₃ Nanowires for Use in Photodetectors

Photodetectors capture optical signals with a wide range of incident photon flux density and convert them to electrical signals instantaneously. They have many important applications including imaging, optical communication, remote control, chemical/biological sensing and so on. Currently, GaN, Si and InGaAs photodetectors are used in commercially available products. Here we demonstrate a novel solution-processed photodetector based on an organic-inorganic hybrid perovskite material. Operating at room temperature, the photodetectors exhibit a large detectivity (the ability to detect weak signals) approaching 10(14) Jones, a linear dynamic range over 100 decibels (dB) and a fast photoresponse with 3-dB bandwidth up to 3 MHz. The performance is significantly better than most of the organic, quantum dot and hybrid photodetectors reported so far; and is comparable, or even better than, the traditional inorganic semiconductor-based photodetectors. Our results indicate that with proper device interface design, perovskite materials are promising candidates for low-cost, high-performance photodetectors.

While organic electronics is mostly dominated by light-emitting diodes, photovoltaic cells and transistors, optoelectronics properties peculiar to organic semiconductors make them interesting candidates for the development of innovative and disruptive applications also in the field of light signal detection. In fact, organic-based photoactive media combine effective light absorption in the region of the spectrum from ultraviolet to near-infrared with good photogeneration yield and low-temperature processability over large areas and on virtually every substrate, which might enable innovative optoelectronic systems to be targeted for instance in the field of imaging, optical communications or biomedical sensing. In this review, after a brief resume of photogeneration basics and of devices operation mechanisms, we offer a broad overview of recent progress in the field, focusing on photodiodes and phototransistors. As to the former device category, very interesting values for figures of merit such as photoconversion efficiency, speed and minimum detectable signal level have been attained, and even though the simultaneous optimization of all these relevant parameters is demonstrated in a limited number of papers, real applications are within reach for this technology, as it is testified by the increasing number of realizations going beyond the single-device level and tackling more complex optoelectronic systems. As to phototransistors, a more recent subject of study in the framework of organic electronics, despite a broad distribution in the reported performances, best photoresponsivities outperform amorphous silicon-based devices. This suggests that organic phototransistors have a large potential to be used in a variety of optoelectronic peculiar applications, such as a photo-sensor, opto-isolator, image sensor, optically controlled phase shifter, and opto-electronic switch and memory. Copyright © 2013 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

One of the major merits of CH3NH3PbI3 perovskite as an efficient absorber material for the photovoltaic cell is its long carrier lifetime. We investigate the role of the intrinsic defects of CH3NH3PbI3 on its outstanding photovoltaic properties using density-functional studies. Two types of defects are of interest, i.e., Schottky defects and Frenkel defects. Schottky defects, such as PbI2 and CH3NH3I vacancy, do not make a trap state, which can reduce carrier lifetime. Elemental defects like Pb, I, and CH3NH3 vacancies derived from Frenkel defects act as dopants, which explains the unintentional doping of methylammonium lead halides (MALHs). The absence of gap states from intrinsic defects of MALHs can be ascribed to the ionic bonding from organic-inorganic hybridization. These results explain why the perovskite MALHs can be an efficient semiconductor, even when grown using simple solution processes. It also suggests that the n-/p-type can be efficiently manipulated by controlling growth processes.