65
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Radiative cooling to deep sub-freezing temperatures through a 24-h day–night cycle

      , , ,
      Nature Communications
      Springer Science and Business Media LLC

      Read this article at

          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Radiative cooling technology utilizes the atmospheric transparency window (8–13 μm) to passively dissipate heat from Earth into outer space (3 K). This technology has attracted broad interests from both fundamental sciences and real world applications, ranging from passive building cooling, renewable energy harvesting and passive refrigeration in arid regions. However, the temperature reduction experimentally demonstrated, thus far, has been relatively modest. Here we theoretically show that ultra-large temperature reduction for as much as 60 °C from ambient is achievable by using a selective thermal emitter and by eliminating parasitic thermal load, and experimentally demonstrate a temperature reduction that far exceeds previous works. In a populous area at sea level, we have achieved an average temperature reduction of 37 °C from the ambient air temperature through a 24-h day–night cycle, with a maximal reduction of 42 °C that occurs when the experimental set-up enclosing the emitter is exposed to peak solar irradiance.

          Related collections

          Most cited references14

          • Record: found
          • Abstract: not found
          • Book: not found

          Handbook of Photovoltaic Science and Engineering

            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Radiative heating and cooling with spectrally selective surfaces.

            Matter continuously exchanges energy with its surroundings. This exchange can be dominated by radiation, conduction, or convection. In this brief review we discuss how proper design of radiative surface properties can be used for heating and cooling purposes. The desired properties can be understood once it is realized that solar and terrestrial radiation take place in different wavelength ranges and that only part of the solar spectrum is useful for vision and for photosynthesis in plants. These facts allow the possibility of tailoring the spectral absorptance, emittance, reflectance, and transmittance of a surface to meet different demands in different wavelength intervals, i.e., to take advantage of spectral selectivity. One example is the selective surface for efficient photothermal conversion of solar energy, which has high absorptance over the solar spectrum but low emittance for the longer wavelengths relevant to thermal reradiation. Below we discuss the pertinent spectral radiative properties of our ambience. These data are then used as background to the subsequent sections treating four examples of spectrally selective surfaces. The first example is the previously mentioned selective surface for converting solar radiation to useful heat. The second example considers surfaces capable of reaching low temperatures by benefiting from the spectral emittance of the clear night sky. The third example concerns two related types of transparent heat mirror. The fourth example, finally, treats radiative cooling of green leaves; this part is included since it gives a nice example of how nature solves a difficult problem in an elegant and efficient way. This example hence provides an interesting background to the other cruder types of artificial selective surfaces. Throughout our discussion we treat the ideal spectral properties, give an illustrative experimental example of how well this goal can be realized, and-where this is possible-show a corresponding theoretical curve indicating to what extent the measured results can be theoretically understood.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Harvesting renewable energy from Earth's mid-infrared emissions.

              It is possible to harvest energy from Earth's thermal infrared emission into outer space. We calculate the thermodynamic limit for the amount of power available, and as a case study, we plot how this limit varies daily and seasonally in a location in Oklahoma. We discuss two possible ways to make such an emissive energy harvester (EEH): A thermal EEH (analogous to solar thermal power generation) and an optoelectronic EEH (analogous to photovoltaic power generation). For the latter, we propose using an infrared-frequency rectifying antenna, and we discuss its operating principles, efficiency limits, system design considerations, and possible technological implementations.
                Bookmark

                Author and article information

                Journal
                Nature Communications
                Nat Commun
                Springer Science and Business Media LLC
                2041-1723
                December 2016
                December 13 2016
                December 2016
                : 7
                : 1
                Article
                10.1038/ncomms13729
                3959e2f1-cc24-48a5-86b2-b00b5edcdb7f
                © 2016

                https://creativecommons.org/licenses/by/4.0

                History

                Comments

                Comment on this article