Pollen-mediated gene flow in maize tested for coexistence of GM and non-GM crops in the Netherlands: effect of isolation distances between fields

We present the first study on cross-fertilization between Bt and conventional maize in real situations of coexistence in two regions in which Bt and conventional maize were cultivated. A map was designed and the different crops were identified, as were the sowing and flowering dates, in Bt and conventional maize fields. These data were used to choose the non-transgenic fields for sampling and analysis by the real-time quantification system-polymerase chain reaction (RTQ-PCR) technique. In general, the rate of cross-fertilization was higher in the borders and, in most of the fields, decreased towards the centre of the field. Nine fields had values of genetically modified organism DNA to total DNA of much lower than 0.9%, whereas in three the rate was higher. Some differences were found when comparing our results with those of common field trials. In real conditions of coexistence and in cropping areas with smaller fields, the main factors that determined cross-pollination were the synchronicity of flowering and the distances between the donor and receptor fields. By establishing an index based on these two variables, the rate of the adventitious presence of genetically modified maize could be predicted, as well as the influence of other factors. By applying this index, and in the case of a fully synchronous flowering time, a security distance between transgenic and conventional fields of about 20 m should be sufficient to maintain the adventitious presence of genetically modified organisms as a result of pollen flow below the 0.9% threshold in the total yield of the field.

A major concern related to the adoption of genetically modified (GM) crops in agricultural systems is the possibility of unwanted GM inputs into non-GM crop production systems. Given the increasing commercial cultivation of GM crops in the European Union (EU), there is an urgent need to define measures to prevent mixing of GM with non-GM products during crop production. Cross-fertilization is one of the various mechanisms that could lead to GM-inputs into non-GM crop systems. Isolation distances between GM and non-GM fields are widely accepted to be an effective measure to reduce these inputs. However, the question of adequate isolation distances between GM and non-GM maize is still subject of controversy both amongst scientists and regulators. As several European countries have proposed largely differing isolation distances for maize ranging from 25 to 800 m, there is a need for scientific criteria when using cross-fertilization data of maize to define isolation distances between GM and non-GM maize. We have reviewed existing cross-fertilization studies in maize, established relevant criteria for the evaluation of these studies and applied these criteria to define science-based isolation distances. To keep GM-inputs in the final product well below the 0.9% threshold defined by the EU, isolation distances of 20 m for silage and 50 m for grain maize, respectively, are proposed. An evaluation using statistical data on maize acreage and an aerial photographs assessment of a typical agricultural landscape by means of Geographic Information Systems (GIS) showed that spatial resources would allow applying the defined isolation distances for the cultivation of GM maize in the majority of the cases under actual Swiss agricultural conditions. The here developed approach, using defined criteria to consider the agricultural context of maize cultivation, may be of assistance for the analysis of cross-fertilization data in other countries.