Technical photosynthesis involving CO2 electrolysis and fermentation

Recent developments in photovoltaic materials have led to continual improvements in their efficiency. We review the electrical characteristics of 16 widely studied geometries of photovoltaic materials with efficiencies of 10 to 29%. Comparison of these characteristics to the fundamental limits based on the Shockley-Queisser detailed-balance model provides a basis for identifying the key limiting factors, related to efficient light management and charge carrier collection, for these materials. Prospects for practical application and large-area fabrication are discussed for each material.

Although considerable progress has been made in direct synthesis gas (syngas) conversion to light olefins (C2(=)-C4(=)) via Fischer-Tropsch synthesis (FTS), the wide product distribution remains a challenge, with a theoretical limit of only 58% for C2-C4 hydrocarbons. We present a process that reaches C2(=)-C4(=) selectivity as high as 80% and C2-C4 94% at carbon monoxide (CO) conversion of 17%. This is enabled by a bifunctional catalyst affording two types of active sites with complementary properties. The partially reduced oxide surface (ZnCrO(x)) activates CO and H2, and C-C coupling is subsequently manipulated within the confined acidic pores of zeolites. No obvious deactivation is observed within 110 hours. Furthermore, this composite catalyst and the process may allow use of coal- and biomass-derived syngas with a low H2/CO ratio.