Pelvic and spinal postural changes between standing-sitting positions following lumbosacral fusion: a pilot study

Abstract

Purpose

Prospective pre-operative and post-operative comparative analysis of radiographic spino-pelvic parameters between sitting versus standing positions of patients with LS fusion, to detect adaptation mechanisms around fused spinal segments.

Methods

Sixteen patients aged 53.9 ± 15.9 who underwent LS fusion between L3 and S1 were extracted from the database of an ongoing prospective study. Different spino-pelvic parameters were evaluated on full spine X-rays, standing, then sitting straight. Parameters were compared pre-operative versus post-operative, and on standing versus sitting X-rays.

Results

Preliminary results revealed a significantly greater pre-operative pelvic tilt (PT) in sitting than standing posture, ( p = 0.020) but not in post-operative ( p = 0.087). After surgery, PT was lower in sitting compared to pre-operative ( p = 0.034) but not in standing ( p = 0.245). L4–S1 lordosis was lower in sitting than standing in pre-operative ( p = 0.014) and post-operative ( p = 0.021). Surgery decreased segmental lordosis above the fusion (PSL, proximal sagittal lordosis) in sitting ( p = 0.039) but not in standing ( p = 0.193). No significant differences in thoracic kyphosis (TK) were observed. Fusions down to L5 versus S1 showed no significant differences for PT and PSL, neither in sitting versus standing, nor pre-operative versus post-operative.

Conclusion

Before fusion, compared to standing, PT increases in sitting straight posture (pelvic retroversion), and the lumbar spine adapts by decreasing its lordosis, mainly at L4–S1. After fusion, the segments adjacent to the instrumented section, adapt in flexion at lumbosacral and thoracolumbar junctions, i.e. just below and above (PSL). This might have mechanical implications for the occurrence of adjacent segment disease.