4
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: not found

      Synthesis and biological evaluation of N-naphthoyl-phenylglyoxamide-based small molecular antimicrobial peptide mimics as novel antimicrobial agents and biofilm inhibitors

      Read this article at

      ScienceOpenPublisher
      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          The synthesis of novel glyoxamide-based antimicrobial peptide mimics is described.

          Abstract

          Antimicrobial peptides (AMPs) are a key component of the human immune system. Synthetic AMP mimics represent a novel strategy to counteract the increasing incidence of antimicrobial resistance. Here, we describe the synthesis of novel glyoxamide derivatives via ring-opening reactions of N-hexanoyl, N-benzoyl and N-naphthoylisatins with N, N-dimethylethane-1,2-diamine and N, N-dimethylpropane-1,3-diamine. These were converted to both the hydrochloric acid (HCl) or quaternary ammonium iodide (MeI) salts and their antibacterial activity against Staphylococcus aureus was investigated by their zone-of-inhibition and minimum inhibitory concentration (MIC). The HCl salt 22b exhibited the lowest MIC of 16 μg mL −1, whereas the corresponding MeI salt 22c had a MIC of 39 μg mL −1. We also investigated the in vitro toxicity of active compounds against the MRC-5 normal human lung fibroblasts and their activity against established biofilm in S. aureus.

          Related collections

          Most cited references31

          • Record: found
          • Abstract: not found
          • Article: not found

          Bacterial Biofilms: A Common Cause of Persistent Infections

            Bookmark
            • Record: found
            • Abstract: found
            • Article: found
            Is Open Access

            Antimicrobial Peptides

            The rapid increase in drug-resistant infections has presented a serious challenge to antimicrobial therapies. The failure of the most potent antibiotics to kill “superbugs” emphasizes the urgent need to develop other control agents. Here we review the history and new development of antimicrobial peptides (AMPs), a growing class of natural and synthetic peptides with a wide spectrum of targets including viruses, bacteria, fungi, and parasites. We summarize the major types of AMPs, their modes of action, and the common mechanisms of AMP resistance. In addition, we discuss the principles for designing effective AMPs and the potential of using AMPs to control biofilms (multicellular structures of bacteria embedded in extracellular matrixes) and persister cells (dormant phenotypic variants of bacterial cells that are highly tolerant to antibiotics).
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Mode of action of membrane active antimicrobial peptides.

              Water-membrane soluble protein and peptide toxins are used in the defense and offense systems of all organisms, including plants and humans. A major group includes antimicrobial peptides, which serve as a nonspecific defense system that complements the highly specific cell-mediated immune response. The increasing resistance of bacteria to conventional antibiotics stimulated the isolation and characterization of many antimicrobial peptides for potential use as new target antibiotics. The finding of thousands of antimicrobial peptides with variable lengths and sequences, all of which are active at similar concentrations, suggests a general mechanism for killing bacteria rather than a specific mechanism that requires preferred active structures. Such a mechanism is in agreement with the "carpet model" that does not require any specific structure or sequence. It seems that when there is an appropriate balance between hydrophobicity and a net positive charge the peptides are active on bacteria. However, selective activity depends also on other parameters, such as the volume of the molecule, its structure, and its oligomeric state in solution and membranes. Further, although many studies support that bacterial membrane damage is a lethal event for bacteria, other studies point to a multihit mechanism in which the peptide binds to several targets in the cytoplasmic region of the bacteria.
                Bookmark

                Author and article information

                Journal
                OBCRAK
                Organic & Biomolecular Chemistry
                Org. Biomol. Chem.
                Royal Society of Chemistry (RSC)
                1477-0520
                1477-0539
                2016
                2016
                : 14
                : 14
                : 3623-3637
                Affiliations
                [1 ]School of Chemistry
                [2 ]UNSW Australia
                [3 ]Sydney
                [4 ]Australia
                [5 ]School of Biotechnology and Biomolecular Sciences
                [6 ]Children's Cancer Institute Australia
                [7 ]Molecular Biosciences Team
                [8 ]School of Life Sciences
                [9 ]University of Technology Sydney
                [10 ]School of Optometry and Vision Science
                Article
                10.1039/C6OB00298F
                ab5b872b-4451-4665-839f-0d17e26f4c0b
                © 2016
                History

                Comments

                Comment on this article