The Effect of the Hip Flexion Angle in Osteonecrosis of the Femoral Head Based on China‐Japan Friendship Hospital Classification ‐ A Finite Element Study

Abstract

Objective

The alteration in the mechanical environment of the necrotic area is the primary cause of the collapse observed in osteonecrosis of the femoral head (ONFH). This study aims to evaluate the biomechanical implications of the China‐Japan Friendship Hospital (CJFH) classification system and hip flexion angles on the necrotic area in ONFH using finite element analysis (FEA). The goal is to provide valuable guidance for hip preservation treatments and serve as a reference for clinical diagnosis and therapeutic interventions.

Methods

Hip tomography CT scan data from a healthy volunteer was used to create a 3D model of the left hip. The model was preprocessed and imported into Solidworks 2018, based on the CJFH classification. Material parameters and boundary conditions were applied to each fractal model in ANSYS 21.0. Von Mises stresses were calculated, and maximum deformation values were obtained to evaluate the biomechanical effects of the load on the necrotic area and post‐necrotic femur, as well as assess each fractal model's collapse risk.

Results

(1) At the same hip flexion angle, maximum deformation followed this order: M Type < C Type < L Type. The L3 type necrotic area experienced the most significant deformation at 0, 60, and 110° angles (1.121, 1.7913, and 1.8239 mm respectively). (2) Under the same CJFH classification, maximum deformation values increased with hip flexion angle (0 < 60 < 110°), suggesting a higher risk of collapse at larger angles. (3) Von Mises stress results showed that the maximum stress was not located in the necrotic area but near the inner and outer edge of the femoral neck, indicating decreased stiffness and strength of the subchondral bone after osteonecrosis.

Conclusion

The study found that femoral head collapse risk was higher when the necrotic area was located in the lateral column under the same stress load and flexion angle. Mechanical properties of the necrotic area changed, resulting in decreased bone strength and stiffness. Large‐angle hip flexion is more likely to cause excessive deformation of the necrotic area; thus, ONFH patients should reduce or avoid large‐angle hip flexion during weight‐bearing training in rehabilitation activities.

Abstract

Deformation cloud diagram of femur under three hip angles based on CJFH classification.