A fully automated multicapillary electrophoresis device for DNA analysis

We have developed a method for the partial automation of DNA sequence analysis. Fluorescence detection of the DNA fragments is accomplished by means of a fluorophore covalently attached to the oligonucleotide primer used in enzymatic DNA sequence analysis. A different coloured fluorophore is used for each of the reactions specific for the bases A, C, G and T. The reaction mixtures are combined and co-electrophoresed down a single polyacrylamide gel tube, the separated fluorescent bands of DNA are detected near the bottom of the tube, and the sequence information is acquired directly by computer.

A DNA sequencing system based on the use of a novel set of four chain-terminating dideoxynucleotides, each carrying a different chemically tuned succinylfluorescein dye distinguished by its fluorescent emission is described. Avian myeloblastosis virus reverse transcriptase is used in a modified dideoxy DNA sequencing protocol to produce a complete set of fluorescence-tagged fragments in one reaction mixture. These DNA fragments are resolved by polyacrylamide gel electrophoresis in one sequencing lane and are identified by a fluorescence detection system specifically matched to the emission characteristics of this dye set. A scanning system allows multiple samples to be run simultaneously and computer-based automatic base sequence identifications to be made. The sequence analysis of M13 phage DNA made with this system is described.

Microchips for integrated capillary electrophoresis systems were produced by molding a poly(dimethylsiloxane) (PDMS) silicone elastomer against a microfabricated master. The good adhesion of the PDMS devices on clean planar surfaces allows for a simple and inexpensive generation of networks of sealed microchannels, thus removing the constraints of elaborate bonding procedures. The performance of the devices is demonstrated with both fast separations of φX-174/HaeIII DNA restriction fragments labeled with the intercalating dye YOYO-1 and fluorescently labeled peptides. Detection limits in the order of a few zeptomoles (10(-)(21) mol) have been achieved for each injected DNA fragment, corresponding to a mass detection limit of ∼2 fg for the 603 base pair fragment. Single λ-DNA molecules intercalated with YOYO-1 at a base pair-to-dye ratio of 10:1 could be detected with an uncomplicated laser-induced fluorescence detection setup. High single-molecule detection efficiency (>50%) was achieved under electrophoretically controlled mass transport conditions in PDMS microchannels.