Molecular Docking and Structure-Based Drug Design Strategies

The Chemscore function was implemented as a scoring function for the protein-ligand docking program GOLD, and its performance compared to the original Goldscore function and two consensus docking protocols, "Goldscore-CS" and "Chemscore-GS," in terms of docking accuracy, prediction of binding affinities, and speed. In the "Goldscore-CS" protocol, dockings produced with the Goldscore function are scored and ranked with the Chemscore function; in the "Chemscore-GS" protocol, dockings produced with the Chemscore function are scored and ranked with the Goldscore function. Comparisons were made for a "clean" set of 224 protein-ligand complexes, and for two subsets of this set, one for which the ligands are "drug-like," the other for which they are "fragment-like." For "drug-like" and "fragment-like" ligands, the docking accuracies obtained with Chemscore and Goldscore functions are similar. For larger ligands, Goldscore gives superior results. Docking with the Chemscore function is up to three times faster than docking with the Goldscore function. Both combined docking protocols give significant improvements in docking accuracy over the use of the Goldscore or Chemscore function alone. "Goldscore-CS" gives success rates of up to 81% (top-ranked GOLD solution within 2.0 A of the experimental binding mode) for the "clean list," but at the cost of long search times. For most virtual screening applications, "Chemscore-GS" seems optimal; search settings that give docking speeds of around 0.25-1.3 min/compound have success rates of about 78% for "drug-like" compounds and 85% for "fragment-like" compounds. In terms of producing binding energy estimates, the Goldscore function appears to perform better than the Chemscore function and the two consensus protocols, particularly for faster search settings. Even at docking speeds of around 1-2 min/compound, the Goldscore function predicts binding energies with a standard deviation of approximately 10.5 kJ/mol. Copyright 2003 Wiley-Liss, Inc.

We present an automatic method for docking organic ligands into protein binding sites. The method can be used in the design process of specific protein ligands. It combines an appropriate model of the physico-chemical properties of the docked molecules with efficient methods for sampling the conformational space of the ligand. If the ligand is flexible, it can adopt a large variety of different conformations. Each such minimum in conformational space presents a potential candidate for the conformation of the ligand in the complexed state. Our docking method samples the conformation space of the ligand on the basis of a discrete model and uses a tree-search technique for placing the ligand incrementally into the active site. For placing the first fragment of the ligand into the protein, we use hashing techniques adapted from computer vision. The incremental construction algorithm is based on a greedy strategy combined with efficient methods for overlap detection and for the search of new interactions. We present results on 19 complexes of which the binding geometry has been crystallographically determined. All considered ligands are docked in at most three minutes on a current workstation. The experimentally observed binding mode of the ligand is reproduced with 0.5 to 1.2 A rms deviation. It is almost always found among the highest-ranking conformations computed.