Piezotronically Modified Double Schottky Barriers in ZnO Varistors

Strain sensors based on individual ZnO piezoelectric fine-wires (PFWs; nanowires, microwires) have been fabricated by a simple, reliable, and cost-effective technique. The electromechanical sensor device consists of a single electrically connected PFW that is placed on the outer surface of a flexible polystyrene (PS) substrate and bonded at its two ends. The entire device is fully packaged by a polydimethylsiloxane (PDMS) thin layer. The PFW has Schottky contacts at its two ends but with distinctly different barrier heights. The I- V characteristic is highly sensitive to strain mainly due to the change in Schottky barrier height (SBH), which scales linear with strain. The change in SBH is suggested owing to the strain induced band structure change and piezoelectric effect. The experimental data can be well-described by the thermionic emission-diffusion model. A gauge factor of as high as 1250 has been demonstrated, which is 25% higher than the best gauge factor demonstrated for carbon nanotubes. The strain sensor developed here has applications in strain and stress measurements in cell biology, biomedical sciences, MEMS devices, structure monitoring, and more.

The fundamental principle of piezotronics and piezo-phototronics were introduced by Wang in 2007 and 2010, respectively. Due to the polarization of ions in a crystal that has non-central symmetry in materials such as the wurtzite structured ZnO, GaN and InN, a piezoelectric potential (piezopotential) is created in the crystal by applying a stress. Owing to the simultaneous possession of piezoelectricity and semiconductor properties, the piezopotential created in the crystal has a strong effect on the carrier transport at the interface/junction. Piezotronics is about the devices fabricated using the piezopotential as a "gate" voltage to tune/control charge carrier transport at a contact or junction. The piezo-phototronic effect is to use the piezopotential to control the carrier generation, transport, separation and/or recombination for improving the performance of optoelectronic devices, such as photon detector, solar cell and LED. This manuscript reviews the updated progress in the two new fields. A perspective is given about their potential applications in sensors, human-silicon technology interfacing, MEMS, nanorobotics and energy sciences. Copyright © 2012 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

Due to polarization of ions in crystals with noncentral symmetry, such as ZnO, GaN, and InN, a piezoelectric potential (piezopotential) is created in the crystal when stress is applied. Electronics fabricated using the inner-crystal piezopotential as a gate voltage to tune or control the charge transport behavior across a metal/semiconductor interface or a p-n junction are called piezotronics. This is different from the basic design of complimentary metal oxide semiconductor (CMOS) field-effect transistors and has applications in force and pressure triggered or controlled electronic devices, sensors, microelectromechanical systems (MEMS), human-computer interfacing, nanorobotics, and touch-pad technologies. Here, the theory of charge transport in piezotronic devices is investigated. In addition to presenting the formal theoretical frame work, analytical solutions are presented for cases including metal-semiconductor contact and p-n junctions under simplified conditions. Numerical calculations are given for predicting the current-voltage characteristics of a general piezotronic transistor: metal-ZnO nanowire-metal device. This study provides important insight into the working principles and characteristics of piezotronic devices, as well as providing guidance for device design. Copyright © 2011 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.