All-solid-state Ti3C2Tx neutral symmetric fiber supercapacitors with high energy density and wide temperature range

There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

Abstract

All-solid-state Ti3C2Tx neutral symmetric fiber supercapacitors (PVA EGHG Ti3C2Tx FSCs) with high energy density and wide temperature range are constructed by using polyvinyl alcohol (PVA)-ethylene glycol hydrogel (EGHG)-sodium perchlorate (NaClO4) as electrolyte and separator, and Ti3C2Tx fiber as electrodes. Ti3C2Tx fiber is prepared using 130 mg mL-1 Ti3C2Tx nanosheet ink as an assembly unit in a coagulation bath of isopropyl alcohol (IPA) and distilled water with 5 wt% CaCl2 by a wet spinning method. The prepared Ti3C2Tx fiber exhibits a specific capacity of 385 F cm-3 and a capacitance retention of 94 % after 10,000 cycles in 1 M NaClO4 electrolyte. The assembled PVA EGHG Ti3C2Tx FSCs deliver a specific capacitance of 41 F cm-3, a volumetric energy density of 5 mWh cm-3, and a capacitance retention of 92 % after 500 times continuous bending. Furthermore, it shows good flexibility and excellent capacitance over a wide temperature range of -40 to 40 °C and maintains its electrochemical performance under varying degrees of bending. This study provides a viable strategy for designing and assembling all-solid-state neutral symmetric fiber supercapacitors with high energy density and wide temperature range.

Related collections

Most cited references 62

Record: found
Abstract: found
Article: not found

Conductive two-dimensional titanium carbide 'clay' with high volumetric capacitance.

Michael Ghidiu, Maria R. Lukatskaya, Meng-Qiang Zhao … (2014)

Safe and powerful energy storage devices are becoming increasingly important. Charging times of seconds to minutes, with power densities exceeding those of batteries, can in principle be provided by electrochemical capacitors--in particular, pseudocapacitors. Recent research has focused mainly on improving the gravimetric performance of the electrodes of such systems, but for portable electronics and vehicles volume is at a premium. The best volumetric capacitances of carbon-based electrodes are around 300 farads per cubic centimetre; hydrated ruthenium oxide can reach capacitances of 1,000 to 1,500 farads per cubic centimetre with great cyclability, but only in thin films. Recently, electrodes made of two-dimensional titanium carbide (Ti3C2, a member of the 'MXene' family), produced by etching aluminium from titanium aluminium carbide (Ti3AlC2, a 'MAX' phase) in concentrated hydrofluoric acid, have been shown to have volumetric capacitances of over 300 farads per cubic centimetre. Here we report a method of producing this material using a solution of lithium fluoride and hydrochloric acid. The resulting hydrophilic material swells in volume when hydrated, and can be shaped like clay and dried into a highly conductive solid or rolled into films tens of micrometres thick. Additive-free films of this titanium carbide 'clay' have volumetric capacitances of up to 900 farads per cubic centimetre, with excellent cyclability and rate performances. This capacitance is almost twice that of our previous report, and our synthetic method also offers a much faster route to film production as well as the avoidance of handling hazardous concentrated hydrofluoric acid.

0 comments Cited 1282 times – based on 0 reviews      Review now

Bookmark

Record: found
Abstract: not found
Article: not found

Materials science. Where do batteries end and supercapacitors begin?

Patrice Simon, Yury Gogotsi, Bruce Dunn (2014)

0 comments Cited 1135 times – based on 0 reviews      Review now

Bookmark

Record: found
Abstract: found
Article: not found

Cation Intercalation and High Volumetric Capacitance of Two-Dimensional Titanium Carbide

M. R. Lukatskaya, O. Mashtalir, C. Ren … (2013)

The intercalation of ions into layered compounds has long been exploited in energy storage devices such as batteries and electrochemical capacitors. However, few host materials are known for ions much larger than lithium. We demonstrate the spontaneous intercalation of cations from aqueous salt solutions between two-dimensional (2D) Ti3C2 MXene layers. MXenes combine 2D conductive carbide layers with a hydrophilic, primarily hydroxyl-terminated surface. A variety of cations, including Na(+), K(+), NH4(+), Mg(2+), and Al(3+), can also be intercalated electrochemically, offering capacitance in excess of 300 farads per cubic centimeter (much higher than that of porous carbons). This study provides a basis for exploring a large family of 2D carbides and carbonitrides in electrochemical energy storage applications using single- and multivalent ions.