5
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Inductively tuned modified split ring resonator based quad band epsilon negative (ENG) with near zero index (NZI) metamaterial for multiband antenna performance enhancement

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          An inductively tuned modified split-ring resonator-based metamaterial (MTM) is presented in this article that provides multiple resonances covering S, C, X, and Ku-bands. The MTM is designed on an FR-4 substrate with a thickness of 1.5 mm and an electrical dimension of 0.063λ × 0.063λ where wavelength, λ is calculated at 2.38 GHz. The resonator part is a combination of three squared copper rings and one circular ring in which all the square rings are modified shaped, and the inner two rings are interconnected. The resonance frequency is tuned by adding inductive metal strips in parallel two vertical splits of the outer ring that causes a significant shift of resonances towards the lower frequencies and a highly effective medium ratio (EMR) of 15.75. Numerical simulation software CST microwave studio is used for the simulation and performance analysis of the proposed unit cell. The MTM unit cell exhibits six resonances of transmission coefficient (S 21) at 2.38, 4.24, 5.98, 9.55, 12.1, and 14.34 GHz covering S, C, X, and Ku-bands with epsilon negative (ENG), near-zero permeability, and near-zero refractive index (NZI). The simulated result is validated by experiment with good agreement between them. The performance of the array of the unit cells is also investigated in both simulation and measurement. The equivalent circuit modeling has been accomplished using Advanced Design Software (ADS) that shows a similar S 21 response compared to CST simulation. Noteworthy to mention that with the copper backplane, the same unit cell provides multiband absorption properties with four major absorption peaks of 99.6%, 95.7%, 99.9%, 92.7% with quality factors(Q-factor) of 28.4, 34.4, 23, and 32 at 3.98, 5.5, 11.73 and 13.47 GHz, respectively which can be applied for sensing and detecting purposes. The application of an array of the unit cells is investigated using it as a superstrate of an antenna that provides a 73% (average) increase of antenna gain. Due to its simple design, compact dimension with high EMR, ENG property with near-zero permeability, this multiband NZI metamaterial can be used for microwave applications, especially for multiband antenna gain enhancement.

          Related collections

          Most cited references48

          • Record: found
          • Abstract: found
          • Article: found
          Is Open Access

          Ror2 signaling regulates Golgi structure and transport through IFT20 for tumor invasiveness

          Signaling through the Ror2 receptor tyrosine kinase promotes invadopodia formation for tumor invasion. Here, we identify intraflagellar transport 20 (IFT20) as a new target of this signaling in tumors that lack primary cilia, and find that IFT20 mediates the ability of Ror2 signaling to induce the invasiveness of these tumors. We also find that IFT20 regulates the nucleation of Golgi-derived microtubules by affecting the GM130-AKAP450 complex, which promotes Golgi ribbon formation in achieving polarized secretion for cell migration and invasion. Furthermore, IFT20 promotes the efficiency of transport through the Golgi complex. These findings shed new insights into how Ror2 signaling promotes tumor invasiveness, and also advance the understanding of how Golgi structure and transport can be regulated.
            Bookmark
            • Record: found
            • Abstract: not found
            • Article: not found

            Robust method to retrieve the constitutive effective parameters of metamaterials

              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Magnetic response of metamaterials at 100 terahertz.

              An array of single nonmagnetic metallic split rings can be used to implement a magnetic resonance, which arises from an inductor-capacitor circuit (LC) resonance, at 100-terahertz frequency. The excitation of the LC resonance in the normal-incidence geometry used in our experiments occurs through the coupling of the electric field of the incident light to the capacitance. The measured optical spectra of the nanofabricated gold structures come very close to the theoretical expectations. Additional numerical simulations show that our structures exhibit a frequency range with negative permeability for a beam configuration in which the magnetic field couples to the LC resonance. Together with an electric response that has negative permittivity, this can lead to materials with a negative index of refraction.
                Bookmark

                Author and article information

                Contributors
                p99997@siswa.ukm.edu.my
                tariqul@ukm.edu.my
                mchowdhury@qu.edu.qa
                Journal
                Sci Rep
                Sci Rep
                Scientific Reports
                Nature Publishing Group UK (London )
                2045-2322
                7 June 2021
                7 June 2021
                2021
                : 11
                : 11950
                Affiliations
                [1 ]GRID grid.412113.4, ISNI 0000 0004 1937 1557, Department of Electrical, Electronic and Systems Engineering, Faculty of Engineering and Built Environment, , Universiti Kebangsaan Malaysia, ; Bangi, Malaysia
                [2 ]GRID grid.443081.a, ISNI 0000 0004 0489 3643, Department of Computer and Communication Engineering, Faculty of Computer Science and Engineering, , Patuakhali Science and Technology University, ; Dhaka, Bangladesh
                [3 ]GRID grid.412113.4, ISNI 0000 0004 1937 1557, Pusat Sains Ankasa (ANGKASA), Institut Perubahan Iklim, , Universiti Kebangsaan Malaysia, ; 43600 UKM Bangi, Selangor Malaysia
                [4 ]GRID grid.412603.2, ISNI 0000 0004 0634 1084, Department of Electrical Engineering, , Qatar University, ; 2713 Doha, Qatar
                Article
                91432
                10.1038/s41598-021-91432-8
                8184967
                34099814
                4384dd3b-eddf-40dc-bce9-1417c0515a3d
                © The Author(s) 2021

                Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article's Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/.

                History
                : 20 March 2021
                : 12 May 2021
                Funding
                Funded by: FundRef http://dx.doi.org/10.13039/501100003093, Ministry of Higher Education, Malaysia;
                Award ID: FRGS/1/2019/TK04/UKM/01/1.
                Award Recipient :
                Funded by: FundRef http://dx.doi.org/10.13039/501100004252, Qatar University;
                Award ID: NPRP12S-0227-190164
                Award Recipient :
                Categories
                Article
                Custom metadata
                © The Author(s) 2021

                Uncategorized
                electrical and electronic engineering,metamaterials
                Uncategorized
                electrical and electronic engineering, metamaterials

                Comments

                Comment on this article