Agar art bridges the gap between science and art using microbes instead of paint. Afterwards, the art can change in response to microbial fluctuation, meaning preservation of the original art is essential. Here, formaldehyde and glutaraldehyde were investigated as preservatives, involving techniques used in healthcare settings to preserve samples.
Formaldehyde was tested at 1.0%, 2.0% and 3.7%, w/v, whereas glutaraldehyde was tested at 1% and 2.5%, w/v. Both compounds and respective concentrations were tested for different time periods. Escherichia coli, Serratia marcescens, Staphlococcus aureus and Micrococcus luteus were used as bacteria for “drawing” the works of art. The effectiveness of fixation was determined using integrated densities and visual assessment. Initially, both compounds showed potential promise, albeit with a loss of bacteria. Ser. marcescens was prone to colour changes and glutaraldehyde caused discolouration of agar and bacteria. These could be caused by a pH decrease in the agar, due to residual free aldehyde groups. Reduction of this was tested using 300 mM sodium metabisulfite to neutralize excess aldehydes. This initially led to reduced bacterial loss and avoided colour changes, however measurements 24 h post‐fixation showed colour loss to some bacterial clusters.
Here, at least 2% formaldehyde for a short fixation period, typically 1 min, depending on the species, was most promising for the preservation of art. Given the success of this with different bacteria, it would make a good starting combination for anyone trying to fix agar art, although methodology refinement may be needed for optimisation depending on the bacterial species used.