Cooling of a suspended nanowire by an AC Josephson current flow

There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

Abstract

We consider a nanoelectromechanical Josephson junction, where a suspended nanowire serves as a superconducting weak link, and show that an applied DC bias voltage an result in suppression of the flexural vibrations of the wire. This cooling effect is achieved through the transfer of vibronic energy quanta first to voltage driven Andreev states and then to extended quasiparticle electronic states. Our analysis, which is performed for a nanowire in the form of a metallic carbon nanotube and in the framework of the density matrix formalism, shows that such self-cooling is possible down to a level where the average occupation number of the lowest flexural vibration mode of the nanowire is \(\sim 0.1\).

Related collections

Most cited references 9

Record: found
Abstract: found
Article: found

Is Open Access

Cooling a nanomechanical resonator with quantum back-action

A. Naik, M P Blencowe, K. C. Schwab … (2006)

Quantum mechanics demands that the act of measurement must affect the measured object. When a linear amplifier is used to continuously monitor the position of an object, the Heisenberg uncertainty relationship requires that the object be driven by force impulses, called back-action. Here we measure the back-action of a superconducting single-electron transistor (SSET) on a radiofrequency nanomechanical resonator. The conductance of the SSET, which is capacitively coupled to the resonator, provides a sensitive probe of the latter's position;back-action effects manifest themselves as an effective thermal bath, the properties of which depend sensitively on SSET bias conditions. Surprisingly, when the SSET is biased near a transport resonance, we observe cooling of the nanomechanical mode from 550mK to 300mK-- an effect that is analogous to laser cooling in atomic physics. Our measurements have implications for nanomechanical readout of quantum information devices and the limits of ultrasensitive force microscopy (such as single-nuclear-spin magnetic resonance force microscopy). Furthermore, we anticipate the use of these backaction effects to prepare ultracold and quantum states of mechanical structures, which would not be accessible with existing technology.

0 comments Cited 156 times – based on 0 reviews

Preprint

     Review now

Bookmark

Record: found
Abstract: found
Article: not found

Ultrasensitive mass sensing with a nanotube electromechanical resonator.

A Bachtold, A Aguasca, B Lassagne … (2008)

Shrinking mechanical resonators to submicrometer dimensions (approximately 100 nm) has tremendously improved capabilities in sensing applications. In this Letter, we go further in size reduction using a 1 nm diameter carbon nanotube as a mechanical resonator for mass sensing. The performances, which are tested by measuring the mass of evaporated chromium atoms, are exceptional. The mass responsivity is measured to be 11 Hz x yg(-1) and the mass resolution is 25 zg at room temperature (1 yg = 10(-24) g and 1 zg = 10(-21) g). By cooling the nanotube down to 5 K in a cryostat, the signal for the detection of mechanical vibrations is improved and corresponds to a resolution of 1.4 zg.